Hello
I was trying to setup /dev/ttyS1 to 115200 baud.
I was using "setserial", kernel 2.2.12 and FIC VA503+ motherboard with
2x16550A integrated in 83877TF controller chip.
After the approppriate "setserial" command I did
cat /proc/tty/driver/serial
And I saw there is 115200 baud set on /dev/ttyS1
so I did
cat /dev/zero > /dev/ttyS1 and looked at my oscilloscope that was
connected to IrDA port connected to /dev/ttyS1
I saw 9600 baud.
So I used protmode assembler utility directly run from boot-floppy
and programmed the 16550A using info from TechHelp!. I used divisor of 1.
The 115200 was correctly seen on the oscilloscope in this case.
How should I tell the serial port in Linux that I really mean 115200?
Best regards,
Karel Kulhavy
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sat Jan 15 2000 - 21:00:16 EST