On Mon, Jan 17, 2000 at 03:07:35PM +0100, Jens Benecke wrote:
> Hi,
>
> The situation is this: When we connect the hardware to the serial port, the
> signal amplitude breaks down to lower than +3V (which is miniumum for the
> PC to detect a "0"). With DOS, the signal amplitude varies from -10..+10 V
> (approx) for 1/0 signals. With Linux, it's -10..<+3V, and that is not
> enough.
Umm - Linux doesn't adjust Power supply voltage levels and it doesn't swap
new serial line driver IC's in place either :-))
You have made __double__ shure you didn't connect two output lines together
(eg. TxD from computer to TxD from your device)? And you also checked your
GND connection?
> Do you have any further ideas about this? Why do the ports behave so much
> differently (no matter if we start setserial or not) when using Linux? In
> theory (yeah, right) it's hardware that should behave the same under any
> OS, at least in respect to voltage levels and power consumption?
Yes, they _do_ behave equally :)
> BTW, we tried three different serial port hardware boards (ISA) so the
> hardware should not be at fault.
...and have booted DOS on the very same computer with the very same ISA-boards
and your device?
How did you build the power supply of your device? An external AC-powersupply
('Netzteil') or from some unused 'to be set to 12V' status lines? If the
latter, are they set to 'high level' when you connect your device?
> I have put the QBasic source and the C source at
> http://www.pinguin.conetix.de/serial.zip, perhaps someone can shed a little
> light on this. There is also a complete DOS floppy boot image including
> QBasic and the .bas file for those who do not have a bootable DOS handy
> (dos.img.gz).
>
> Thanks a lot!
Keine Ursache!
Thorsten
-- | Thorsten Kranzkowski Internet: dl8bcu@gmx.net | | Mobile: ++49 161 7210230 Snail: Niemannsweg 30, 49201 Dissen, Germany | | Ampr: dl8bcu@db0lj.#rpl.deu.eu, dl8bcu@marvin.dl8bcu.ampr.org [44.130.8.19] |- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sun Jan 23 2000 - 21:00:16 EST