Re: eepro100 not working properly

From: Jeff Garzik (jgarzik@mandrakesoft.com)
Date: Mon Feb 14 2000 - 01:23:06 EST

Next message: Richard Gooch: "[PATCH] devfs v157 available"
Previous message: Rusty Russell: "Re: getting more that 4K out of a proc file? [PATCH]"
In reply to: Jens Axboe: "eepro100 not working properly"
Next in thread: Jens Axboe: "Re: eepro100 not working properly"
Reply: Jens Axboe: "Re: eepro100 not working properly"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Jens Axboe wrote:
> eepro100 does not work well after the 2.3.45 changes. It works after
> a cold boot, but after a warm reboot no go. The device is detected
> and eth0 brought up, but I get no response from the other end.

Can you check and see if this behavior exists in 2.3.45-pre2 also?

I enabled Becker's ACPI logic in 2.3.45 eepro100, and that sounds like
it may be the culprit.

-- Jeff Garzik | Writing software is Building 1024 | more fun than working. MandrakeSoft, Inc. | -Anon

- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/

Next message: Richard Gooch: "[PATCH] devfs v157 available"
Previous message: Rusty Russell: "Re: getting more that 4K out of a proc file? [PATCH]"
In reply to: Jens Axboe: "eepro100 not working properly"
Next in thread: Jens Axboe: "Re: eepro100 not working properly"
Reply: Jens Axboe: "Re: eepro100 not working properly"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b29 : Tue Feb 15 2000 - 21:00:26 EST