Setting BT878 tuner type with linked BT848?

From: Matthias Andree (ma@dt.e-technik.uni-dortmund.de)
Date: Sat Apr 01 2000 - 12:48:08 EST

Hi,

I seem to be unable to find documentation on how to set the tuner type
for my bttv or tuner drivers when the BT8xx-driver is statically linked
against the kernel.

Setting options in conf.modules when bttv and tuner are modules is
fine, though with linked bttv/tuner, the tuner is not working, its type
sticks with "-1" (unset).

Hauppauge(new) WinTV pci here (Bt878+TDA6300+MSP3410D-B4 (NICAM))

I get these during boot:
i2c: initialized
Linux video capture interface: v1.00
bttv0: Brooktree Bt878 (rev 2) bus: 0, devfn: 72, irq: 12, memory:
0xe1003000.
bttv: 1 Bt8xx card(s) found.
bttv0: fader chip: TEA6300
bttv0: model: BT878(Hauppauge new)
msp3400: daemon started
msp3400: init: chip=MSP3410D-B4, has NICAM support

and this upon starting xawtv:

bttv0: PLL: 28636363 => 35468950 ... ok
tuner: tuner type not set

I have this /proc/cmdline:

mem=131008K root=/dev/hda7 ide0=dma ide0=autotune \
sym53c8xx=tags:32,debug:0x200,specf:1 tuner=type=5 \
bttv=card=10,type=5,tuner=5

Looking at the bttv/tuner source, this does not even remotely seem
correct, IF at all bttv and tuner parse LILO options.

Any pointers, please? 

-- 
Matthias Andree

                Where do you think you're going today?

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/

This archive was generated by hypermail 2b29 : Fri Apr 07 2000 - 21:00:07 EST