I'm having trouble getting an Avance Logic ALS-100 to work properly.
Upn modprobe of sb.o i get:
Apr 13 01:19:01 fogarty kernel: Soundblaster audio driver Copyright
(C) by Hannu Savolainen 1993-1996
Apr 13 01:19:01 fogarty kernel: sb: ALS100 Media Audio Controller
detected
Apr 13 01:19:01 fogarty kernel: sb: ISAPnP reports 'ALS100 Media
Audio Controller' at i/o 0x220, irq 5, dma 1, 5
Apr 13 01:19:01 fogarty kernel: SB 4.02 detected OK (220)
Apr 13 01:19:01 fogarty kernel: <Sound Blaster 16 (ALS-100) (4.02)>
at 0x220 irq 5 dma 1,5
Apr 13 01:19:01 fogarty kernel: sb: 1 Soundblaster PnP card(s) found.
which looks fine.
If i try to play an 8 bit wav, everything is fine.
If i try to play an mpg-3, i get about 2 seconds of sound, after
which nothing, and the following in my logs:
Apr 13 01:20:12 fogarty kernel: Sound: DMA (output) timed out -
IRQ/DRQ config error?
I can still play 8 bit wav's though.
cat /proc/isapnp:
Card 1 'ALS0001:ALS100 Media Audio Controller' PnP version 1.0
Logical device 0 '@@@0001:Unknown'
Supported registers 0x2
Device is active
Active port 0x220
Active IRQ 5 [0x2]
Active DMA 5,1
Resources 0
Priority preferred
Port 0x220-0x220, align 0x0, size 0x10, 10-bit address decoding
IRQ 5 High-Edge
DMA 5 16-bit word-count type-A
DMA 1 8-bit byte-count type-A
Alternate resources 0:1
Priority acceptable
Port 0x220-0x280, align 0x1f, size 0x10, 10-bit address
decoding
IRQ 5,7,2/9,10 High-Edge
DMA 5,6,7 16-bit word-count type-A
DMA 0,1,3 8-bit byte-count type-A
Alternate resources 0:2
Priority functional
Port 0x100-0x3f0, align 0xf, size 0x10, 10-bit address
decoding
IRQ 5,7,2/9,10,11,12,15 High-Edge Low-Edge High-Level
Low-Level
DMA 0,1,3,5,6,7 8-bit&16-bit byte-count word-count type-A
Logical device 1 '@H@0001:Unknown'
Supported registers 0x2
Device is not active
Active port 0x388
Resources 0
Priority preferred
Port 0x388-0x388, align 0x0, size 0x8, 10-bit address decoding
Logical device 2 '@P@0001:Unknown'
Supported registers 0x2
Device is not active
Active port 0x200
Resources 0
Priority preferred
Port 0x200-0x200, align 0x0, size 0x2, 10-bit address decoding
Logical device 3 '@X@0001:Unknown'
Supported registers 0x2
Device is not active
Resources 0
Priority preferred
Port 0x330-0x330, align 0x0, size 0x2, 10-bit address decoding
IRQ 5,7,10 High-Edge
Alternate resources 0:1
Priority acceptable
Port 0x100-0x3f0, align 0xf, size 0x2, 10-bit address
decoding
IRQ 5,7,10 High-Edge Low-Edge High-Level Low-Level
regards,
-- Paul Jakma paul@clubi.ie PGP5 key: http://www.clubi.ie/jakma/publickey.txt ------------------------------------------- Fortune: You mean you didn't *know* she was off making lots of little phone companies?- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sat Apr 15 2000 - 21:00:20 EST