szenario: ssh to my LAN servers - did ldconfig - several symlinks broken -
scrolled up - used mouse to copy the ldconfig output -> kernel panic (the
first time i tried) - oops (the second time after the reboot)
after the oops i tried, because my other consoles seemed to work, to copy
the oops output to a file but then the givem console screwed up as well.
(the command i entered oopsd) (netscape, pico dmesg ...etc)
below my dmesg and the log file of the oops
---- CUT ----
May 26 19:16:17 ns1 kernel: Unable to handle kernel paging request at
virtual address 56b556bd
May 26 19:16:17 ns1 kernel: Unable to handle kernel paging request at
virtual address 56b556bd
May 26 19:16:17 ns1 kernel: Unable to handle kernel paging request at
virtual address 56b556bd
May 26 19:16:17 ns1 kernel: current->tss.cr3 = 058ea000, %cr3 = 058ea000
May 26 19:16:17 ns1 kernel: current->tss.cr3 = 058ea000, %cr3 = 058ea000
May 26 19:16:17 ns1 kernel: current->tss.cr3 = 058ea000, %cr3 = 058ea000
May 26 19:16:17 ns1 kernel: *pde = 00000000
May 26 19:16:17 ns1 kernel: *pde = 00000000
May 26 19:16:17 ns1 kernel: *pde = 00000000
May 26 19:16:17 ns1 kernel: Oops: 0000
May 26 19:16:17 ns1 kernel: Oops: 0000
May 26 19:16:17 ns1 kernel: CPU: 0
May 26 19:16:17 ns1 kernel: CPU: 0
---- CUT ----
Linux version 2.2.14 (root@ns1) (gcc version egcs-2.91.66 19990314/Linux (egcs-1.1.2 release)) #3 Sun May 7 14:16:14 CEST 2000
Detected 300685476 Hz processor.
Console: colour dummy device 80x25
Calibrating delay loop... 299.83 BogoMIPS
Memory: 257220k/262080k available (1492k kernel code, 416k reserved, 2876k data, 76k init)
Dentry hash table entries: 32768 (order 6, 256k)
Buffer cache hash table entries: 262144 (order 8, 1024k)
Page cache hash table entries: 65536 (order 6, 256k)
VFS: Diskquotas version dquot_6.4.0 initialized
CPU: Intel Pentium II (Klamath) stepping 04
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.35a (19990819) Richard Gooch (rgooch@atnf.csiro.au)
PCI: PCI BIOS revision 2.10 entry at 0xf0750
PCI: Using configuration type 1
PCI: Probing PCI hardware
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
TCP: Hash tables configured (ehash 262144 bhash 65536)
Initializing RT netlink socket
Starting kswapd v 1.5
parport0: PC-style at 0x378 (0x778) [SPP,ECP,ECPEPP,ECPPS2]
parport0: detected irq 7; use procfs to enable interrupt-driven operation.
vesafb: framebuffer at 0xe3000000, mapped to 0xd0000000, size 4096k
vesafb: mode is 1024x768x16, linelength=2048, pages=1
vesafb: protected mode interface info at c000:79e0
vesafb: scrolling: redraw
vesafb: directcolor: size=1:5:5:5, shift=15:10:5:0
Console: switching to colour frame buffer device 128x48
fb0: VESA VGA frame buffer device
Detected PS/2 Mouse Port.
Serial driver version 4.27 with no serial options enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
pty: 256 Unix98 ptys configured
lp0: using parport0 (polling).
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.9)
Sound initialization started
<Sound Blaster 16 (4.16)> at 0x220 irq 5 dma 1,5
<Sound Blaster 16> at 0x330 irq 5 dma 0
Sound initialization complete
ISDN subsystem Rev: 1.93/1.80/1.95/1.60/1.17/1.3
ICN-ISDN-driver Rev 1.62 mem=0x000d0000
icn: (line0) ICN-2B, port 0x320 added
HiSax: Linux Driver for passive ISDN cards
HiSax: Version 3.3c (kernel)
HiSax: Layer1 Revision 2.36
HiSax: Layer2 Revision 2.20
HiSax: TeiMgr Revision 2.13
HiSax: Layer3 Revision 2.10
HiSax: LinkLayer Revision 2.40
HiSax: Approval certification valid
HiSax: Approved with ELSA Quickstep series cards
HiSax: Approval registration numbers:
HiSax: German D133361J CETECOM ICT Services GmbH
HiSax: EU (D133362J) CETECOM ICT Services GmbH
HiSax: Approved with Eicon Technology Diva 2.01 PCI cards
HiSax: Total 1 card defined
HiSax: Card 1 Protocol EDSS1 Id=HiSax (1)
HiSax: AVM PCI driver Rev. 1.14
FritzPCI: No PCI card found
HiSax: Card AVM Fritz PnP/PCI not installed !
loop: registered device at major 7
PIIX4: IDE controller on PCI bus 00 dev 21
PIIX4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xd800-0xd807, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xd808-0xd80f, BIOS settings: hdc:pio, hdd:pio
hda: IBM-DHEA-36480, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: IBM-DHEA-36480, 6197MB w/476kB Cache, CHS=790/255/63, UDMA
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
(scsi0) <Adaptec AIC-7880 Ultra SCSI host adapter> found at PCI 6/0
(scsi0) Wide Channel, SCSI ID=7, 16/255 SCBs
(scsi0) Downloading sequencer code... 413 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.21/3.2.4
<Adaptec AIC-7880 Ultra SCSI host adapter>
scsi : 1 host.
(scsi0:0:0:0) Synchronous at 10.0 Mbyte/sec, offset 8.
Vendor: PLEXTOR Model: CD-R PX-R412C Rev: 1.07
Type: CD-ROM ANSI SCSI revision: 02
(scsi0:0:1:0) Synchronous at 20.0 Mbyte/sec, offset 15.
Vendor: PLEXTOR Model: CD-ROM PX-32TS Rev: 1.01
Type: CD-ROM ANSI SCSI revision: 02
(scsi0:0:6:0) Synchronous at 40.0 Mbyte/sec, offset 8.
Vendor: IBM Model: DDRS-39130W Rev: S92A
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 6, lun 0
scsi : detected 1 SCSI disk total.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 17850000 [8715 MB] [8.7 GB]
Partition check:
sda: sda2 sda3 sda4
hda: hda1 hda2
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 76k freed
Adding Swap: 136544k swap-space (priority -1)
Adding Swap: 136544k swap-space (priority -2)
Checking ReiserFS transaction log (device 08:03) ...
Replayed 1 transactions in 2 seconds
ReiserFS core development sponsored by SuSE Labs (suse.com)
Journaling sponsored by MP3.com
Item handlers sponsored by Ecila.com
ReiserFS version 3.5.18
Checking ReiserFS transaction log (device 08:04) ...
Replayed 1 transactions in 5 seconds
ReiserFS version 3.5.18
PPP: version 2.3.7 (demand dialling)
PPP line discipline registered.
PPP BSD Compression module registered
rtl8139.c:v1.07 5/6/99 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/rtl8139.html
eth0: RealTek RTL8139 Fast Ethernet at 0xb800, IRQ 9, 00:00:b4:aa:7c:49.
tulip.c:v0.91g-ppc 7/16/99 becker@cesdis.gsfc.nasa.gov
eth1: Digital DC21041 Tulip rev 33 at 0xb400, 00:80:C8:4E:55:E5, IRQ 10.
eth1: 21041 Media table, default media 0800 (Autosense).
eth1: 21041 media #0, 10baseT.
eth1: 21041 media #4, 10baseT-FD.
eth1: 21041 media #1, 10base2.
==============================================
| |
| Fr0sT of PsiTec.OrG [http://outfit.2y.net] |
| <fr0st@linuxfreaks.com> |
| |
==============================================
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Wed May 31 2000 - 21:00:16 EST