I compiled the ac6 release of 2.4.0test1. Now i seem to have lost support
for DMA on my system.
I just get these messages during boot :
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
PIIX4: dma_base is invalid (0xf000)
ide0: PIIX4 Bus-Master DMA disabled (BIOS)
PIIX4: dma_base is invalid (0xf000)
ide1: PIIX4 Bus-Master DMA disabled (BIOS)
HPT366: onboard version of chipset, pin1=1 pin2=2
HPT366: IDE controller on PCI bus 00 dev 98
HPT366: chipset revision 1
HPT366: not 100% native mode: will probe irqs later
HPT366: dma_base is invalid (0xd800)
ide2: HPT366 Bus-Master DMA disabled (BIOS)
HPT366: IDE controller on PCI bus 00 dev 99
HPT366: chipset revision 1
HPT366: not 100% native mode: will probe irqs later
HPT366: dma_base is invalid (0xe400)
ide3: HPT366 Bus-Master DMA disabled (BIOS)
It is strange as my DMA has worked without any problems before. I tried to
reenable DMA with the
help of hdparm. Then i got this error :
/dev/hda:
setting using_dma to 1 (on)
HDIO_SET_DMA failed: Operation not permitted
using_dma = 0 (off)
What is wrong ?? Without DMA the system is very sluggish...
/Mikael 'Nik' Grahn - Mindkiller Systems -
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Wed May 31 2000 - 21:00:26 EST