The following is the output from dmesg on my Toshiba CD4090CDS Laptop at
work..
The machine runs fine with 2.3.99-pre6, but with kernels versions
2.3.99-pre9 & 2.4.0-test1, the pcmcia ethernet card doesn't work
with a no high memory space error at bootup :-(
If its fixed, i'll shut up & go away, if not, is there any more info that
would be of use ?
ps, is this message of any significance ? sounds pretty serious to me !
PCI: Address space collision on region 8 of device Intel Corporation 82371AB
PIIX4 ACPI [fe60:fe7f]
Linux version 2.4.0-test1 (root@leelaptop) (gcc version egcs-2.91.66
19990314/Linux (egcs-1.1.2 release)) #48 Wed May 31 11:05:41 BST 2000
BIOS-provided physical RAM map:
e820: 000000000009fc00 @ 0000000000000000 (usable)
e820: 0000000000000400 @ 000000000009fc00 (reserved)
e820: 0000000000004000 @ 00000000000e8000 (usable)
e820: 0000000000010000 @ 00000000000f0000 (reserved)
e820: 0000000003ee0000 @ 0000000000100000 (usable)
e820: 0000000000010000 @ 0000000003fe0000 (ACPI data)
e820: 0000000000010000 @ 0000000003ff0000 (reserved)
e820: 0000000000016e00 @ 00000000100a0000 (reserved)
e820: 0000000000000200 @ 00000000100b6e00 (ACPI NVS)
e820: 0000000000049000 @ 00000000100b7000 (reserved)
e820: 0000000000080000 @ 00000000fff80000 (reserved)
user-defined physical RAM map:
e820: 000000000009f000 @ 0000000000000000 (usable)
e820: 0000000003d00000 @ 0000000000100000 (usable)
Scan SMP from c0000000 for 1024 bytes.
Scan SMP from c009fc00 for 1024 bytes.
Scan SMP from c00f0000 for 65536 bytes.
Scan SMP from c009fc00 for 4096 bytes.
On node 0 totalpages: 15872
zone(0): 4096 pages.
zone(1): 11776 pages.
zone(2): 0 pages.
mapped APIC to ffffe000 (01119000)
Kernel command line: BOOT_IMAGE=devel ro root=305 mem=62M
Initializing CPU#0
Detected 399934044 Hz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 797.90 BogoMIPS
Memory: 60480k/63488k available (1044k kernel code, 2620k reserved, 73k
data, 180k init, 0k highmem)
Dentry-cache hash table entries: 8192 (order: 4, 65536 bytes)
Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes)
Page-cache hash table entries: 16384 (order: 4, 65536 bytes)
kmem_create: Poisoning requested, but con given - bdev_cache
Inode-cache hash table entries: 4096 (order: 3, 32768 bytes)
kmem_create: Poisoning requested, but con given - inode_cache
VFS: Diskquotas version dquot_6.4.0 initialized
CPU: Intel Celeron (Mendocino) stepping 0a
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.36 (20000221) Richard Gooch (rgooch@atnf.csiro.au)
PCI: PCI BIOS revision 2.10 entry at 0xfedcd, last bus=21
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Using IRQ router PIIX [8086/122e] at 00:05.0
Limiting direct PCI/PCI transfers.
PCI: Address space collision on region 8 of device Intel Corporation 82371AB
PIIX4 ACPI [fe60:fe7f]
isapnp: Scanning for Pnp cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.3
Based upon Swansea University Computer Society NET3.039
kmem_create: Poisoning requested, but con given - skbuff_head_cache
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 4096 bind 4096)
apm: BIOS version 1.2 Flags 0x02 (Driver version 1.13)
Starting kswapd v1.6
pty: 256 Unix98 ptys configured
Uniform Multi-Platform E-IDE driver Revision: 6.30
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev 29
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xfe60-0xfe67, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xfe68-0xfe6f, BIOS settings: hdc:DMA, hdd:pio
hda: TOSHIBA MK4313MAT, ATA DISK drive
hdc: CD-224E, ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: 8452080 sectors (4327 MB), CHS=526/255/63, UDMA(33)
Partition check:
hda: hda1 hda2 < hda5 hda6 >
Linux PCMCIA Card Services 3.1.11
options: [pci] [cardbus] [pm]
Adding cardbus controller 0: Toshiba America Info Systems ToPIC95
PCI: Enabling device 00:02.0 (0000 -> 0002)
Yenta IRQ list 04b0, PCI irq11
Socket status: 30000011
Adding cardbus controller 1: Toshiba America Info Systems ToPIC95 (#2)
PCI: Enabling device 00:02.1 (0000 -> 0002)
Yenta IRQ list 04b0, PCI irq11
Socket status: 30000007
Intel PCIC probe: not found.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 180k freed
Adding Swap: 104380k swap-space (priority -1)
Serial driver version 4.93 (2000-03-20) with MANY_PORTS SHARE_IRQ SERIAL_PCI
ISAPNP enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
cs: IO port probe 0x1000-0x17ff: clean.
cs: IO port probe 0x0100-0x04ff: excluding 0x378-0x37f 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.
cs: memory probe 0xa0000000-0xa0ffffff: excluding 0xa0000000-0xa0ffffff
cs: memory probe 0x60000000-0x60ffffff: excluding 0x60000000-0x60ffffff
cs: warning: no high memory space available!
cs: memory probe 0x0d0000-0x0dffff: excluding 0xd0000-0xdffff
cs: memory probe 0x0c0000-0x0cffff: excluding 0xc0000-0xcffff
Lee Mitchell
www.spamtastic.demon.co.uk
lee@spamtastic.demon.co.uk
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Wed May 31 2000 - 21:00:28 EST