Remi Turk wrote:
> > Ok, the problem is that you have an interrupt router table for your Ali
> > 1533, but no interrupt router entry for your IDE device. That's why
> > pci_enable_device is failing.
> >
> > Would you mind testing two kernel patches for me? Both of these changes
> > should be attempted separately in 2.4.0-test10-pre6, and -without-
> > Andre's change.
> >
> > The first change attempts to build an interrupt router entry for you, if
> > none is available. I am most interested if this works.
> >
> > The second change simply ignores any pci_enable_device error returns,
> > and assumes that the IDE subsystem will pick up the pieces.
> >
> > Remember, do not apply both of these changes at the same time...
> >
> > Thanks,
> >
> > Jeff
>
> The second patch (the one ignoring errors) doesn't seem to change
> anything (except not giving the warning IIRC)
> Also, dump_pirq and lspci -vv output didn't change.
>
> The first says the following at boot:
>
> PCI: PCI BIOS revision 2.10 entry at 0xf0560, last bus=1
> PCI: Using configuration type 1
> PCI: Probing PCI hardware
> Unknown bridge resource 0: assuming transparent
> PCI: Using IRQ router ALI [10b9/1533] at 00:07.0
> PCI: Found IRQ 14 for device 00:0f.0
>
> dump_pirq output remains the same.
> The lspci -vv output does change with the second patch:
>
> 00:0f.0 IDE interface: Acer Laboratories Inc. M5229 (rev c1) (prog-if
> fa)
> Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
> Stepping- SERR- FastB2B-
> Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
> <TAbort- <MAbort- >SERR- <PERR-
> Latency: 2 min, 4 max, 32 set
> - Interrupt: pin A routed to IRQ 0
> + Interrupt: pin A routed to IRQ 14
> Region 4: I/O ports at d000
>
> More info on request.
>
Hm, while running with the first patch (the one trying to build
an interrupt router table for my chipset) my system locked solid
for a few seconds while I was copying the kernel-source to another
place and moved from one virtual screen to another in X.
It happened just once, but I don't remember the last time I had
this kind of latency. At the same time I noticed this in my
kernel logs:
localhost kernel: cdrom: open failed.
I haven't done anything with my cdrom since the last reboot.
localhost modprobe: modprobe: Can't locate module block-major-33
localhost modprobe: modprobe: Can't locate module block-major-33
localhost modprobe: modprobe: Can't locate module block-major-34
localhost modprobe: modprobe: Can't locate module block-major-34
localhost modprobe: modprobe: Can't locate module block-major-8
localhost last message repeated 15 times
I only have hd[a-c]
(timestamps removed to prevent irritating wrapping,
they were all in the same minute)
My dmesg is attached, just in case.
-- Linux 2.4.0-test10-pre6-test1 #1 Sat Oct 28 23:04:32 CEST 2000
Linux version 2.4.0-test10-pre6-test1 (src@localhost.localdomain) (gcc version egcs-2.91.66 19990314/Linux (egcs-1.1.2 release)) #1 Sat Oct 28 23:04:32 CEST 2000 BIOS-provided physical RAM map: BIOS-e820: 00000000000a0000 @ 0000000000000000 (usable) BIOS-e820: 0000000000010000 @ 00000000000f0000 (reserved) BIOS-e820: 000000000fefc000 @ 0000000000100000 (usable) BIOS-e820: 0000000000003000 @ 000000000fffc000 (ACPI data) BIOS-e820: 0000000000001000 @ 000000000ffff000 (ACPI NVS) BIOS-e820: 0000000000010000 @ 00000000ffff0000 (reserved) Scan SMP from c0000000 for 1024 bytes. Scan SMP from c009fc00 for 1024 bytes. Scan SMP from c00f0000 for 65536 bytes. Scan SMP from c0000000 for 4096 bytes. On node 0 totalpages: 65532 zone(0): 4096 pages. zone(1): 61436 pages. zone(2): 0 pages. mapped APIC to ffffe000 (01444000) Kernel command line: Initializing CPU#0 Detected 350.802 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 699.60 BogoMIPS Memory: 255780k/262128k available (1099k kernel code, 5964k reserved, 85k data, 184k init, 0k highmem) Dentry-cache hash table entries: 32768 (order: 6, 262144 bytes) Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes) Page-cache hash table entries: 65536 (order: 6, 262144 bytes) Inode-cache hash table entries: 16384 (order: 5, 131072 bytes) VFS: Diskquotas version dquot_6.4.0 initialized CPU: L1 I Cache: 32K L1 D Cache: 32K (32 bytes/line) CPU: AMD-K6(tm) 3D processor stepping 00 Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX PCI: PCI BIOS revision 2.10 entry at 0xf0560, last bus=1 PCI: Using configuration type 1 PCI: Probing PCI hardware Unknown bridge resource 0: assuming transparent PCI: Using IRQ router ALI [10b9/1533] at 00:07.0 PCI: Found IRQ 14 for device 00:0f.0 Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket apm: BIOS version 1.2 Flags 0x03 (Driver version 1.13) Starting kswapd v1.8 Detected PS/2 Mouse Port. pty: 256 Unix98 ptys configured Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ALI15X3: IDE controller on PCI bus 00 dev 78 ALI15X3: chipset revision 193 ALI15X3: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xd000-0xd007, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0xd008-0xd00f, BIOS settings: hdc:DMA, hdd:pio hda: QUANTUM FIREBALL EL5.1A, ATA DISK drive hdb: CD-ROM 36X/AKW, ATAPI CDROM drive ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx hdc: QUANTUM FIREBALLP KA13.6, ATA DISK drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: 10018890 sectors (5130 MB) w/418KiB Cache, CHS=10602/15/63, UDMA(33) hdc: 27067824 sectors (13859 MB) w/371KiB Cache, CHS=26853/16/63, UDMA(33) hdb: ATAPI 36X CD-ROM drive, 128kB Cache, DMA Uniform CD-ROM driver Revision: 3.11 Partition check: hda: hda1 hdc: hdc1 hdc2 hdc3 hdc4 Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 LVM version 0.8final by Heinz Mauelshagen (15/02/2000) lvm -- Driver successfully initialized Serial driver version 5.02 (2000-08-09) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A Real Time Clock Driver v1.10d NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP IP: routing cache hash table of 2048 buckets, 16Kbytes TCP: Hash tables configured (established 16384 bind 16384) ip_tables: (c)2000 Netfilter core team NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 184k freed Adding Swap: 133552k swap-space (priority -1) ip_conntrack (2047 buckets, 16376 max) Creative EMU10K1 PCI Audio Driver, version 0.11, 23:58:36 Oct 28 2000 emu10k1: EMU10K1 rev 4 model 0x20 found, IO at 0xd800-0xd81f, IRQ 10 ac97_codec: AC97 codec, vendor id1: 0x5452, id2: 0x4103 (TriTech TR?????) CSLIP: code copyright 1989 Regents of the University of California PPP generic driver version 2.4.1 PPP BSD Compression module registered PPP Deflate Compression module registered VFS: Disk change detected on device fd(2,0) cdrom: open failed. VFS: Disk change detected on device ide0(3,64)
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Tue Oct 31 2000 - 21:00:24 EST