On Thu, Dec 14, 2000 at 12:00:13PM -0500, Jeff Garzik wrote:
> Russell King wrote:
> > Maybe the right thing to do is to define CONFIG_ISA on these architectures/
> > machine types where the device itself is actually an ISA device, instead of
> > going through special-casing the driver configuration entries?
>
> Agreed. We -don't- want to remove CONFIG_ISA or other dependencies.
> The idea for drivers/net/Config.in at least is that all architectures
> can source the file, and be presented with a proper list of devices for
> that platform.
>
> For an embedded board that supports cs89x0, as you suggest, defining
> CONFIG_ISA is a much better option. Or, making cs89x0 dependent on
> CONFIG_EMBEDDED_PLATFORM -and- CONFIG_ISA.
No, the cs89x0 can be used on systems that don't have an ISA bus at
all. It just needs 16 data lines, a couple of address lines and some
selection lines, but that's all. It's very nice for embedded designs
because it's a single chip solution. Add a 20MHz crystal, a
transformer, and a connector and you're set.
OK, what about this patch. As far as I know, the cs89x0 is only used on
Intel SA11x0 and Cirrus PS7500FE platforms in the ARM world (Russell,
please correct me if I'm wrong). This patch make it dependent on
CONFIG_ISA, CONFIG_ARCH_SA1100, or CONFIG_ARCH_CLPS7500.
Erik
PS: Your CVS hints work, Jeff :-)
Index: drivers/net/Config.in
===================================================================
RCS file: /home/erik/cvsroot/elinux/drivers/net/Config.in,v
retrieving revision 1.1.1.39
diff -u -r1.1.1.39 Config.in
--- drivers/net/Config.in 2000/12/07 14:16:21 1.1.1.39
+++ drivers/net/Config.in 2000/12/14 18:34:01
@@ -134,7 +138,9 @@
fi
tristate ' Apricot Xen-II on board Ethernet' CONFIG_APRICOT
- dep_tristate ' CS89x0 support' CONFIG_CS89x0 $CONFIG_ISA
+ if [ "$CONFIG_ISA" = "y" -o "$CONFIG_ARCH_SA1100" = "y" -o "$CONFIG_ARCH_CLPS7500" = "y" ] ; then
+ tristate ' CS89x0 support' CONFIG_CS89x0
+ fi
dep_tristate ' DECchip Tulip (dc21x4x) PCI support' CONFIG_TULIP $CONFIG_PCI
if [ "$CONFIG_PCI" = "y" -o "$CONFIG_EISA" = "y" ]; then
tristate ' Generic DECchip & DIGITAL EtherWORKS PCI/EISA' CONFIG_DE4X5
-- J.A.K. (Erik) Mouw, Information and Communication Theory Group, Department of Electrical Engineering, Faculty of Information Technology and Systems, Delft University of Technology, PO BOX 5031, 2600 GA Delft, The Netherlands Phone: +31-15-2783635 Fax: +31-15-2781843 Email: J.A.K.Mouw@its.tudelft.nl WWW: http://www-ict.its.tudelft.nl/~erik/ - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Fri Dec 15 2000 - 21:00:30 EST