Hi Rob,
Just out of curiosity, did you use a 2.2 series
.config file and then run make oldconfig or did
you build a new .config file from scratch?
I have periodically built kernels that crashed
immediately at the point you mention. Usually this
was due to me choose configuration options that
were incompatible with my machine's hardware.
Another time, the machine wouldn't boot because
I needed a new version of LILO. I also have seen
at least one machine where I needed to specify
"linear" as one of the options in lilo.conf.
If you aren't specifying "linear" now, give it
a try.
IIRC, here's my litany of goofed configurations:
Building support for multiple framebuffer
devices. Apparently, the kernel would
hang in the chip detection process.
Wrong CPU architecture.
Wrong IDE chipset specified.
Built EXT2 as a module, but / was on
an EXT2 partition.
I may have hit some other bogus configurations
over the last two years, but these are ones that
come to mind.
Miles
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Mon Jan 15 2001 - 21:00:24 EST