Re: bttv problems in 2.4.0/2.4.1

From: adrian (jimbud@lostland.net)
Date: Wed Jan 31 2001 - 08:06:19 EST


On Tue, 30 Jan 2001, Matthew Gabeler-Lee wrote:

> On Tue, 30 Jan 2001, adrian wrote:
>
> > I have a bt848 based video capture card, and get near the same results:
> > 2.4.0-test10 through 2.4.1 all lock when i2c registers the device. The
> > card has its own interrupt. With 2.2.18, the card initialized and the
> > kernel continued to boot. Interesting.
>
> 2 questions:
> What card in particular do you have?
> What version of the bttv drivers were you using in 2.4.0-test10?
> It comes with 0.7.38; did you patch it to a higher version?
>
> --
> -Matt
>

The card is a video only capture that came with a camera (and has a
connector to power that camera next to the video connector). Hauppauge is
silkscreened on the PCB, along with Axiom Design. I didn't buy it, so all
I have to go off of is what's on the card. So here's all of it.

Sticker on back: 58051 REV A 231383
On Bt chip: Bt848kpf video decoder 255 9637

As far as the bttv driver version, I've always used the ones that came
originally with that kernel version.

This is what lspci says:
00:0f.0 Multimedia video controller: Brooktree Corporation Bt848 (rev 11)
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 16 min, 40 max, 64 set
        Interrupt: pin A routed to IRQ 9
        Region 0: Memory at eddfe000 (32-bit, prefetchable)

A cat of /proc/pci reports REV 17 instead of 11.

Regards,
Adrian

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
Please read the FAQ at http://www.tux.org/lkml/



This archive was generated by hypermail 2b29 : Wed Jan 31 2001 - 21:00:38 EST