quintaq@yahoo.co.uk wrote:
> I have an IBM DTLA 307030 (ATA 100 / UDMA 5) on an 815e board (Asus CUSL2), which has a PIIX4 controller.
> ...
> My problem is that (according to hdparm -t), I never get a better transfer rate than approximately 15.8 Mb/sec. I achieve this when DMA is enabled, - without it I fall back to about 5 Mb /sec. No amount of fiddling with other hdparm settings makes any difference.
> ...
15MB/s for hdparm is about right.
"...four IDE devices can be supported in Bus Master mode.
PIIX4 contains support for "Ultra DMA/33" synchronous DMA
compatible devices."
http://developer.intel.com/design/intarch/techinfo/440BX/PIIX4_intro.htm
-- - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Fri Mar 23 2001 - 21:00:12 EST