The first attempt at mounting a disc in my Traxdata CDR drive after boot always
fails. From the second on, everything works flawlessly.
Current setup is 2.2.18 kernel + 6.1.11-2.2.18 patch, but I've been experiencing
this behaviour since I bought the adapter (around 2.2.12 or so).
aic7xxx gets loaded as a module.
Here's some diagnostic info from the failed mount. If more is needed, please let
me know.
(of course, a disc _is_ present in the drive).
# modprobe aic7xxx
Apr 13 11:20:04 aidi kernel: ahc_pci:0:12:0: Host Adapter Bios disabled. Using default SCSI device parameters
Apr 13 11:20:04 aidi kernel: scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.1.11
Apr 13 11:20:04 aidi kernel: <Adaptec 2902/04/10/15/20/30C SCSI adapter>
Apr 13 11:20:04 aidi kernel: aic7850: Single Channel A, SCSI Id=7, 3/255 SCBs
Apr 13 11:20:04 aidi kernel:
Apr 13 11:20:04 aidi kernel: scsi : 1 host.
Apr 13 11:20:10 aidi kernel: Vendor: Traxdata Model: CDR4120 Rev: 5.0L
Apr 13 11:20:10 aidi kernel: Type: CD-ROM ANSI SCSI revision: 02
Apr 13 11:20:10 aidi kernel: (scsi0:A:6): 10.000MB/s transfers (10.000MHz, offset 15)
# mount /dev/sr0 /mnt/cd2
Apr 13 11:21:39 aidi kernel: Detected scsi CD-ROM sr0 at scsi0, channel 0, id 6, lun 0
Apr 13 11:22:09 aidi kernel: scsi0:0:6:0: Attempting to queue an ABORT message
Apr 13 11:22:09 aidi kernel: (scsi0:A:6:0): Queuing a recovery SCB
Apr 13 11:22:09 aidi kernel: scsi0:0:6:0: Device is disconnected, re-queuing SCB
Apr 13 11:22:09 aidi kernel: Recovery code sleeping
Apr 13 11:22:09 aidi kernel: (scsi0:A:6:0): Abort Message Sent
Apr 13 11:22:09 aidi kernel: (scsi0:A:6:0): SCB 3 - Abort Completed.
Apr 13 11:22:09 aidi kernel: Recovery SCB completes
Apr 13 11:22:09 aidi kernel: Recovery code awake
Apr 13 11:22:09 aidi kernel: aic7xxx_abort returns 8194
Apr 13 11:22:09 aidi kernel: scsi0:0:6:0: Attempting to queue a TARGET RESET message
Apr 13 11:22:09 aidi kernel: scsi0:0:6:0: Command not found
Apr 13 11:22:09 aidi kernel: aic7xxx_dev_reset returns 8194
Apr 13 11:22:14 aidi kernel: sr0: CD-ROM not ready. Make sure you have a disc in the drive.
Apr 13 11:22:14 aidi kernel: CD-ROM I/O error: dev 0b:00, sector 64
Apr 13 11:22:14 aidi kernel: isofs_read_super: bread failed, dev=0b:00, iso_blknum=16, block=32
# lspci -v
[snip]
00:0c.0 SCSI storage controller: Adaptec AHA-7850 (rev 03)
Subsystem: Adaptec AHA-2904/Integrated AIC-7850
Flags: bus master, medium devsel, latency 32, IRQ 11
I/O ports at 9800 [disabled]
Memory at de800000 (32-bit, non-prefetchable)
Capabilities: [dc] Power Management version 1
[snip]
Cheers,
David
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sun Apr 15 2001 - 21:00:21 EST