---Reply to mail from Venkatesh Ramamurthy about Solution - AMI megaraid driver doesn't work with Linux 2.4.x kernels
> Can you provide the dmesg output of your system after loading the driver
> either successfully or unsucessfully.
>
Successfully: (Raid 5 4x18GB)
------------------------------------------------------
megaraid: v1.14g (Release Date: Feb 5, 2001; 11:42)
megaraid: found 0x101e:0x1960:idx 0:bus 9:slot 0:func 0
scsi3 : Found a MegaRAID controller at 0xf884e000, IRQ: 17
scsi3 : Enabling 64 bit support
megaraid: [G158:3.11] detected 1 logical drives
scsi3 : AMI MegaRAID G158 254 commands 16 targs 2 chans 40 luns
scsi3: scanning channel 1 for devices.
Vendor: ESG-SHV Model: SCA HSBP M9 Rev: 0.10
Type: Processor ANSI SCSI revision: 02
scsi3: scanning channel 2 for devices.
scsi3: scanning virtual channel for logical drives.
Vendor: MegaRAID Model: LD0 RAID5 52527R Rev: G158
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi disk sdb at scsi3, channel 2, id 0, lun 0
SCSI device sdb: 107575296 512-byte hdwr sectors (55079 MB)
sdb: sdb1
-------------------------------------------------------
When it was unsucessfully, it stoppet in the last line with:
sdb: unknown partition table
(With kernel 2.4.2-2smp from redhat (RH7.1) and "official" 2.4.2, 2.4.3)
The only different between the to instalations is the firmware version
C158 --> G158 of the ami card.
The kernel is a 2.4.2-2smp from redhat (RH7.1). I will test the system with an
"official" ;-) kernel today.
Rafael Martinez
---End reply
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Mon May 07 2001 - 21:00:19 EST