Steve,
Dream on fellow, it is SOP that upon media failure the device logs the
failure and does an internal re-allocation in the slip-sector stream.
If the media is out of slip-sectors then it does an out-of-bounds
re-allocation. Once the total number of out-of-bounds sectors are gone
you need to deal with getting new media or exectute a seek and purge
operation; however, if the badblock list is full you are toast.
That is what is done - knowledge is first hand.
Regards,
Andre Hedrick
CEO/President, LAD Storage Consulting Group
Linux ATA Development
Linux Disk Certification Project
On Mon, 26 Nov 2001, Steve Brueggeman wrote:
> While I am not familiar with the IBM drives in particular, I am
> familar with this particular problem.
>
> The problem is that half of a sector gets new data, then when power is
> dropped, the old data+CRC/ECC is left on second part of that sector,
> and a subsequent read on the whole sector will detect the CRC/ECC
> mismatch, and determine the error burst is larger than what it can
> correct with retries, and ECC, and report it as a HARD ERROR. (03-1100
> in the SCSI World)
>
> Since the error is non-recoverable, the disk drive should not
> auto-reassign the sector, since it cannot succeed at moving good data
> to the newly assigned sector.
>
> This type of error does not require a low-level format. Just writing
> any data to the sector in error should give the sector a CRC/ECC field
> that matches the data in the sector, and you should not get hard
> errors when reading that sector anymore.
>
> This was more of a problem with older disk drives (8-Inch platters, or
> older), because the time required to finish any given sector was more
> than the amount of time the electronics would run reliably. All that
> could be guranteed on these older drives was that a power loss would
> not corrupt any adjacent data, ie write gate must be crow-bared
> inactive before the heads start retracting, emergency-style, to the
> landing zone.
>
> I believe that the time to complete a sector is so short on current
> drives, that they should be able to complete writing their current
> sector, but I do not believe that there are any drive manufacturers
> out there that gurrantee this. Thus, there is probably a window, on
> all disk drives out there, where a loss of power durring an active
> write will end up causing a hard error when that sector is
> subsequently read (I haven't looked though, and could be wrong).
> Writing to the sector with the error should clear the hard-error when
> that sector is read. A low-level format should not be required to fix
> this, and if it is, the drive is definitely broken in design.
>
> This is basic power-economics, and one of the reasons for UPS's
>
> Steve Brueggeman
>
>
>
> On 24 Nov 2001 14:03:11 +0100, you wrote:
>
> >In the German computer community, a statement from IBM[1] is
> >circulating which describes a rather peculiar behavior of certain IBM
> >IDE hard drivers (the DTLA series):
> >
> >When the drive is powered down during a write operation, the sector
> >which was being written has got an incorrect checksum stored on disk.
> >So far, so good---but if the sector is read later, the drive returns a
> >*permanent*, *hard* error, which can only be removed by a low-level
> >format (IBM provides a tool for it). The drive does not automatically
> >map out such sectors.
> >
> >IBM claims this isn't a firmware error, but thinks that this explains
> >the failures frequently observed with DTLA drivers (which might
> >reflect reality or not, I don't know, but that's not the point
> >anyway).
> >
> >Now my question: Obviously, journaling file systems do not work
> >correctly on drivers with such behavior. In contrast, a vital data
> >structure is frequently written to (the journal), so such file systems
> >*increase* the probability of complete failure (with a bad sector in
> >the journal, the file system is probably unusable; for non-journaling
> >file systems, only a part of the data becomes unavailable). Is the
> >DTLA hard disk behavior regarding aborted writes more common among
> >contemporary hard drives? Wouldn't this make journaling pretty
> >pointless?
> >
> >
> >1. http://www.cooling-solutions.de/dtla-faq (German)
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Fri Nov 30 2001 - 21:00:23 EST