On Wed, Dec 19, 2001 at 11:20:22AM -0500, Mark Hahn wrote:
> > > I do have an Asus P2B-S Mainboard and since a week I have a Maxtor 60 GB
>
> that's piix-based, is it not?
It is BX-chipset, not exactly sure if this is what is called piix. But I
think so and found this in /proc/ide/pix
Intel PIIX4 Ultra 33 Chipset.
--------------- Primary Channel ---------------- Secondary Channel
------------- enabled enabled
--------------- drive0 --------- drive1 -------- drive0 ---------- drive1
------DMA enabled: yes no yes no
UDMA enabled: yes no yes no
UDMA enabled: 2 X 2 X
UDMA
DMA
PIO
> > > Timing buffered disk reads: 64 MB in 5.63 seconds = 11.37 MB/sec
>
> should be more like 30 MB/s, so you must not have the piix controller
> in your kernel.
I was expecting something above 20MB/s, and thus I wondered about the low
values. Well and when I tried first time, my computer was not really idle
and thus I only got something around 3.5 MB/s.
OK, what do I need to compile into my kernel to have the chipset configured
fine? Or do I need any boot-parameters?
Here is an excerpt from my kernel-config:
CONFIG_IDE=y
CONFIG_BLK_DEV_IDEDISK=y
CONFIG_IDEDISK_MULTI_MODE=y
CONFIG_BLK_DEV_IDECD=m
CONFIG_BLK_DEV_IDEPCI=y
CONFIG_IDEPCI_SHARE_IRQ=y
CONFIG_BLK_DEV_IDEDMA_PCI=y
CONFIG_BLK_DEV_ADMA=y
CONFIG_BLK_DEV_OFFBOARD=y
CONFIG_IDEDMA_PCI_AUTO=y
CONFIG_BLK_DEV_IDEDMA=y
CONFIG_BLK_DEV_PIIX=y
CONFIG_PIIX_TUNING=y
CONFIG_IDE_CHIPSETS=y
CONFIG_IDEDMA_AUTO=y
CONFIG_BLK_DEV_IDE_MODES=y
everything skipped is just not set.
Thanks, thomas
-- thomas@deselaers.de «<>» JabberID on request «<>» GPG/PGP key on request «< Unless stated otherwise everything I write is just my opinion >» - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sun Dec 23 2001 - 21:00:19 EST