On December 19, 2001 09:32, Thomas Deselaers wrote:
> I do have an Asus P2B-S Mainboard and since a week I have a Maxtor 60 GB
> 5400 rpm Harddrive (MAXTOR 4K060H3).
I am experiencing extremely shoddy performance with a similar disk/chipset
combination. I am on an Asus P2B-DS board (440BX) with the following disk
setup.
hda: Maxtor 93073U6, ATA DISK drive
hdc: Maxtor 90840D6, ATA DISK drive
hdd: Maxtor 90840D6, ATA DISK drive
I am barely experiencing the same performance you are, after enabling all the
stuff that's been discussed in this thread. I'd like to determine if this
disk is dying or if there is something seriously wrong with my kernel. I did
not seem to experience anything until I went to 2.4.16. hdd seems to be
headed for the heap, as all tests on it fail. I am stumped; I've read the
manual and the threads and still haven't extracted proper performance. All
help is appreciated.
Thanks,
AKK
Following is the information on the other disks and the hdparm test results:
# hdparm -t /dev/hda
/dev/hda:
Timing buffered disk reads: 64 MB in 86.98 seconds =753.46 kB/sec
# hdparm /dev/hda ; hdparm -i /dev/hda
/dev/hda:
multcount = 16 (on)
I/O support = 1 (32-bit)
unmaskirq = 0 (off)
using_dma = 1 (on)
keepsettings = 0 (off)
nowerr = 0 (off)
readonly = 0 (off)
readahead = 8 (on)
geometry = 3736/255/63, sectors = 60030432, start = 0
busstate = 1 (on)
/dev/hda:
Model=Maxtor 93073U6, FwRev=FA500S60, SerialNo=G607E80C
Config={ Fixed }
RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=57
BuffType=DualPortCache, BuffSize=2048kB, MaxMultSect=16, MultSect=16
CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=60030432
IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120}
PIO modes: pio0 pio1 pio2 pio3 pio4
DMA modes: mdma0 mdma1 mdma2 udma0 udma1 *udma2 udma3 udma4
AdvancedPM=yes: disabled (255) WriteCache=enabled
Drive Supports : ATA/ATAPI-4 T13 1153D revision 17 : ATA-1 ATA-2 ATA-3 ATA-4
ATA-5
/dev/hdc:
Timing buffered disk reads: 64 MB in 5.63 seconds = 11.37 MB/sec
/dev/hdc:
multcount = 16 (on)
I/O support = 1 (32-bit)
unmaskirq = 0 (off)
using_dma = 1 (on)
keepsettings = 0 (off)
nowerr = 0 (off)
readonly = 0 (off)
readahead = 8 (on)
geometry = 1021/255/63, sectors = 16406208, start = 0
busstate = 1 (on)
/dev/hdc:
Model=Maxtor 90840D6, FwRev=WAS82739, SerialNo=K606M2WA
Config={ Fixed }
RawCHS=16276/16/63, TrkSize=0, SectSize=0, ECCbytes=29
BuffType=DualPortCache, BuffSize=256kB, MaxMultSect=16, MultSect=16
CurCHS=16276/16/63, CurSects=16406208, LBA=yes, LBAsects=16406208
IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120}
PIO modes: pio0 pio1 pio2 pio3 pio4
DMA modes: mdma0 mdma1 mdma2 udma0 udma1 *udma2
AdvancedPM=no WriteCache=enabled
Drive Supports : ATA/ATAPI-4 T13 1153D revision 17 : ATA-1 ATA-2 ATA-3 ATA-4
-- akk~- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sun Dec 23 2001 - 21:00:26 EST