I can't boot pre7 but pre6 works every time. AIC7XXX controller with
a single drive.
It looks like it gets some kind of error when it is looking for disks.
Hard to get the message it prints out because it looks like it is
trying every possible LUN. The original message scrolls off and I cant
page back because new lines put me back to the current line.
pre7 is not a good thing. A pre6 dmesg reports the following on a
good boot:
SCSI subsystem driver Revision: 1.0
scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.4
<Adaptec aic7896/97 Ultra2 SCSI adapter>
aic7896/97: Ultra2 Wide Channel A, SCSI Id=7, 32/253 SCBs
scsi1 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.4
<Adaptec aic7896/97 Ultra2 SCSI adapter>
aic7896/97: Ultra2 Wide Channel A, SCSI Id=7, 32/253 SCBs
Vendor: SEAGATE Model: ST31840LW Rev: 0006
Type: Direct-Access ANSI SCSI revision: 03
(scsi0:A:0) 80.000MB/s transfers (40.000MHz, offset 63, 16bit)
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
Partition check:
sda: sda1 sda2 sda3
On the failed boot I get scsi0:0:0:0: Attempting to queue ABORT
message right after it posts the scsi0 and scsi1 controller info and
it looks like it just starts going from scsi0:0:0:0 to 0:0:1:0,
0:0:2:0, 0:0:3:0, etc looking for a disk.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Thu Jan 31 2002 - 21:00:24 EST