On Sat, 2002-06-22 at 08:57, Adam J. Richter wrote:
> linux-2.5.24/drivers/net/hamradio/soundmodem/Makefile contains
> the following rule:
>
> $(obj)/sm_tbl_%: $(obj)/gentbl
> $<
>
> obj was set to "." /usr/src/linux/Rules.make, which was included
> earlier in the Makefile.
>
> The problem is that when make executes this rule it executes
> "gentbl" rather than "./gentbl". This causes the command to fail if
> you do not have "." in your path. Make-3.79.1 is apparently being too
> clever in expanding file names. I think this is a make bug.
Thanks for investigating this, but I propose another fix, namely to
remove soundmodem altogether. Linus, please do:
rm -rf drivers/net/hamradio/soundmodem
and then apply the attached patch.
Why?
* There is a usermode only replacement now (and for several years
already), which works with most OSS interface sound drivers
* The kernel stuff is limited to a few ISA cards, and nowadays
mainboards with ISA slots almost ceased to exist, same with ISA
soundcards
Thanks
Tom
--- linux-2.5.24/drivers/net/hamradio/Config.in.sm Mon Jun 24 17:22:03 2002
+++ linux-2.5.24/drivers/net/hamradio/Config.in Mon Jun 24 17:22:44 2002
@@ -18,18 +18,5 @@
dep_tristate 'BAYCOM picpar and par96 driver for AX.25' CONFIG_BAYCOM_PAR $CONFIG_PARPORT $CONFIG_AX25
dep_tristate 'BAYCOM epp driver for AX.25' CONFIG_BAYCOM_EPP $CONFIG_PARPORT $CONFIG_AX25
-dep_tristate 'Soundcard modem driver' CONFIG_SOUNDMODEM $CONFIG_PARPORT $CONFIG_AX25
-if [ "$CONFIG_SOUNDMODEM" != "n" ]; then
- bool ' soundmodem support for Soundblaster and compatible cards' CONFIG_SOUNDMODEM_SBC
- bool ' soundmodem support for WSS and Crystal cards' CONFIG_SOUNDMODEM_WSS
- bool ' soundmodem support for 1200 baud AFSK modulation' CONFIG_SOUNDMODEM_AFSK1200
- bool ' soundmodem support for 2400 baud AFSK modulation (7.3728MHz crystal)' CONFIG_SOUNDMODEM_AFSK2400_7
- bool ' soundmodem support for 2400 baud AFSK modulation (8MHz crystal)' CONFIG_SOUNDMODEM_AFSK2400_8
- bool ' soundmodem support for 2666 baud AFSK modulation' CONFIG_SOUNDMODEM_AFSK2666
- bool ' soundmodem support for 4800 baud HAPN-1 modulation' CONFIG_SOUNDMODEM_HAPN4800
- bool ' soundmodem support for 4800 baud PSK modulation' CONFIG_SOUNDMODEM_PSK4800
- bool ' soundmodem support for 9600 baud FSK G3RUH modulation' CONFIG_SOUNDMODEM_FSK9600
-fi
-
dep_tristate 'YAM driver for AX.25' CONFIG_YAM $CONFIG_AX25
--- linux-2.5.24/drivers/net/hamradio/Makefile.sm Mon Jun 24 17:22:07 2002
+++ linux-2.5.24/drivers/net/hamradio/Makefile Mon Jun 24 17:22:30 2002
@@ -22,6 +22,5 @@
obj-$(CONFIG_BAYCOM_SER_HDX) += baycom_ser_hdx.o hdlcdrv.o
obj-$(CONFIG_BAYCOM_PAR) += baycom_par.o hdlcdrv.o
obj-$(CONFIG_BAYCOM_EPP) += baycom_epp.o hdlcdrv.o
-obj-$(CONFIG_SOUNDMODEM) += soundmodem/ hdlcdrv.o
include $(TOPDIR)/Rules.make
--- linux-2.5.24/drivers/net/hamradio/Config.help.sm Mon Jun 24 17:23:49 2002
+++ linux-2.5.24/drivers/net/hamradio/Config.help Mon Jun 24 17:24:13 2002
@@ -161,87 +161,3 @@
say M here and read <file:Documentation/modules.txt>. This is
recommended. The module will be called baycom_ser_hdx.o.
-CONFIG_SOUNDMODEM
- This experimental driver allows a standard Sound Blaster or
- WindowsSoundSystem compatible sound card to be used as a packet
- radio modem (NOT as a telephone modem!), to send digital traffic
- over amateur radio.
-
- To configure the driver, use the sethdlc, smdiag and smmixer
- utilities available in the standard ax25 utilities package. For
- information on how to key the transmitter, see
- <http://www.ife.ee.ethz.ch/~sailer/pcf/ptt_circ/ptt.html> and
- <file:Documentation/networking/soundmodem.txt>.
-
- If you want to compile this driver as a module ( = code which can be
- inserted in and removed from the running kernel whenever you want),
- say M here and read <file:Documentation/modules.txt>. This is
- recommended. The module will be called soundmodem.o.
-
-CONFIG_SOUNDMODEM_SBC
- This option enables the soundmodem driver to use Sound Blaster and
- compatible cards. If you have a dual mode card (i.e. a WSS cards
- with a Sound Blaster emulation) you should say N here and Y to
- "Sound card modem support for WSS and Crystal cards", below, because
- this usually results in better performance. This option also
- supports SB16/32/64 in full-duplex mode.
-
-CONFIG_SOUNDMODEM_WSS
- This option enables the soundmodem driver to use WindowsSoundSystem
- compatible cards. These cards feature a codec chip from either
- Analog Devices (such as AD1848, AD1845, AD1812) or Crystal
- Semiconductors (such as CS4248, CS423x). This option also supports
- the WSS full-duplex operation which currently works with Crystal
- CS423x chips. If you don't need full-duplex operation, do not enable
- it to save performance.
-
-CONFIG_SOUNDMODEM_AFSK1200
- This option enables the soundmodem driver 1200 baud AFSK modem,
- compatible to popular modems using TCM3105 or AM7911. The
- demodulator requires about 12% of the CPU power of a Pentium 75 CPU
- per channel.
-
-CONFIG_SOUNDMODEM_AFSK2400_7
- This option enables the soundmodem driver 2400 baud AFSK modem,
- compatible to TCM3105 modems (over-)clocked with a 7.3728MHz
- crystal. Note that the availability of this driver does _not_ imply
- that I recommend building such links. It is only here since users
- especially in eastern Europe have asked me to do so. In fact this
- modulation scheme has many disadvantages, mainly its incompatibility
- with many transceiver designs and the fact that the TCM3105 (if
- used) is operated widely outside its specifications.
-
-CONFIG_SOUNDMODEM_AFSK2400_8
- This option enables the soundmodem driver 2400 baud AFSK modem,
- compatible to TCM3105 modems (over-)clocked with an 8MHz crystal.
- Note that the availability of this driver does _not_ imply that I
- recommend building such links. It is only here since users
- especially in eastern Europe have asked me to do so. In fact this
- modulation scheme has many disadvantages, mainly its incompatibility
- with many transceiver designs and the fact that the TCM3105 (if
- used) is operated widely outside its specifications.
-
-CONFIG_SOUNDMODEM_AFSK2666
- This option enables the soundmodem driver 2666 baud AFSK modem.
- This modem is experimental, and not compatible to anything
- else I know of.
-
-CONFIG_SOUNDMODEM_PSK4800
- This option enables the soundmodem driver 4800 baud 8PSK modem.
- This modem is experimental, and not compatible to anything
- else I know of.
-
-CONFIG_SOUNDMODEM_HAPN4800
- This option enables the soundmodem driver 4800 baud HAPN-1
- compatible modem. This modulation seems to be widely used 'down
- under' and in the Netherlands. Here, nobody uses it, so I could not
- test if it works. It is compatible to itself, however :-)
-
-CONFIG_SOUNDMODEM_FSK9600
- This option enables the soundmodem driver 9600 baud FSK modem,
- compatible to the G3RUH standard. The demodulator requires about 4%
- of the CPU power of a Pentium 75 CPU per channel. You can say Y to
- both 1200 baud AFSK and 9600 baud FSK if you want (but obviously you
- can only use one protocol at a time, depending on what the other end
- can understand).
-
--- linux-2.5.24/Makefile.sm Mon Jun 24 17:23:00 2002
+++ linux-2.5.24/Makefile Mon Jun 24 17:23:20 2002
@@ -599,10 +599,6 @@
# files removed with 'make mrproper'
MRPROPER_FILES += \
include/linux/autoconf.h include/linux/version.h \
- drivers/net/hamradio/soundmodem/sm_tbl_{afsk1200,afsk2666,fsk9600}.h \
- drivers/net/hamradio/soundmodem/sm_tbl_{hapn4800,psk4800}.h \
- drivers/net/hamradio/soundmodem/sm_tbl_{afsk2400_7,afsk2400_8}.h \
- drivers/net/hamradio/soundmodem/gentbl \
sound/oss/*_boot.h sound/oss/.*.boot \
sound/oss/msndinit.c \
sound/oss/msndperm.c \
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sun Jun 30 2002 - 22:00:07 EST