Hi,
I wrote here about my problems with promise pdc controller in smp
configuration, and I was told that I'm using bad hardware (VIA chipset)
and blah-blah-blah...
Well, I've changed hardware to UP P4 box based on i845e chipset...
Now I've got the following messages on kernel boot, and of cause no DMA
on ide channels (even with hdparm):
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ICH4: IDE controller on PCI bus 00 dev f9
PCI: Device 00:1f.1 not available because of resource collisions
ICH4: (ide_setup_pci_device:) Could not enable device.
here is lspci output:
00:1f.1 IDE interface: Intel Corp.: Unknown device 24cb (rev 01) (prog-if 8a
+[Master SecP PriP])
Subsystem: Micro-star International Co Ltd: Unknown device 5661
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
+Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
+<TAbort- <MAbort- >SERR- <PERR-
Latency: 0
Interrupt: pin A routed to IRQ 18
Region 0: I/O ports at <unassigned> [size=8]
Region 1: I/O ports at <unassigned> [size=4]
Region 2: I/O ports at <unassigned> [size=8]
Region 3: I/O ports at <unassigned> [size=4]
Region 4: I/O ports at fc00 [size=16]
Region 5: Memory at 20000000 (32-bit, non-prefetchable) [size=1K]
What should I do with my hardware? Through it away? round and around?!
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sun Jun 30 2002 - 22:00:13 EST