Hi,
sorry, if this has been asked before, but I could not find any in the
archives.
I have a Gigabyte GA7DXR with a onboard Promise PDC20265 IDE-Controller.
Attached to this Controller are 4 Maxtor 120 GB Disks.
Booting with 2.4.18 works fine. The partitons of the disk are detecded,
and I can access them.
Booting with 2.4.19-rc1 hangs on bootup.
The Promise is detected correctly.
But when it comes to the partition-check the systems hangs:
looks like this:
------snippel-------
PDC20265: chipset revision 2
PDC20265: not 100% native mode: will probe irqs later
PDC20265: (U)DMA Burst Bit ENABLED Primary PCI Mode Secondary PCI Mode.
ide2: BM-DMA at 0xc800-0xc807, BIOS settings: hde:pio, hdf:pio
ide3: BM-DMA at 0xc808-0xc80f, BIOS settings: hdg:DMA, hdh:DMA
hda: IBM-DHEA-36481, ATA DISK drive
hde: Maxtor 4G120J6, ATA DISK drive
hdf: Maxtor 4G120J6, ATA DISK drive
hdg: Maxtor 4G120J6, ATA DISK drive
hdh: Maxtor 4G120J6, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide2 at 0xb800-0xb807,0xbc02 on irq 11
ide3 at 0xc000-0xc007,0xc402 on irq 11
hda: 12692736 sectors (6499 MB) w/472KiB Cache, CHS=790/255/63, UDMA(33)
hde: 240121728 sectors (122942 MB) w/2048KiB Cache, CHS=238216/16/63,
UDMA(100)
hdf: 240121728 sectors (122942 MB) w/2048KiB Cache, CHS=238216/16/63,
UDMA(100)
hdg: 240121728 sectors (122942 MB) w/2048KiB Cache, CHS=238216/16/63,
UDMA(100)
hdh: 240121728 sectors (122942 MB) w/2048KiB Cache, CHS=238216/16/63,
UDMA(100)
Partition check:
hda: hda1 hda2 hda3
hde:
--------------
And here it hangs
Because the patch between 2.4.18 and 2.4.19-rc1 is very big, there seem
to be a lot of changes.
Thanks in andvance for any help.....
--Bye
Ernst --------- Ernst Lehmann Email: lehmann@acheron.franken.de
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Tue Jul 23 2002 - 22:00:19 EST