On Sun, 4 Aug 2002 13:28:46 +0000 (UTC), Henning P. Schmiedehausen
wrote:
>Bartlomiej Zolnierkiewicz <B.Zolnierkiewicz@elka.pw.edu.pl> writes:
>>On 4 Aug 2002, Alan Cox wrote:
>>> On Sat, 2002-08-03 at 23:16, Bartlomiej Zolnierkiewicz wrote:
>>> > Just rethough it. What if chipset is in compatibility mode?
>>> > Like VIA with base addresses set to 0?
>>>
>>> If we found a register that was marked as unassigned with a size then we
>>> would map it to a PCI address. That would go for BAR0-3 on any PCI IDE
>>> device attached to the south bridge.
>
>>In compatibility mode IDE chipsets have IO at legacy ISA ports and
>>PCI_BASE_ADDRESS0-3 are set to them or to zero (at least on VIA).
>>And they can't be programmed to any other ports (unless native mode).
>this sounds like a problem that I have with the ServerWorks OSB5
>chipset. I actually have PCI_BASE_ADDRESS0-3 at 0 and
>PCI_BASE_ADDRESS4 = 0x3a0.
>
>Does this hold true here, too? Or is this VIA specific?
PCI IDE controller chips in compatibility mode may exhibit the
following BAR0-3 values (sorted by likelihood of occurance):
most likely: BAR0-3 are all zero
rare : BAR0-3 show the legacy IDE port values
very rare : BAR0-3 contain garbage
In fact, the best strategy is to *ignore* BAR0-3 in compatibility mode
because they have no meaning then!
Ciao,
Dani
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Wed Aug 07 2002 - 22:00:24 EST