> All the pre2-acX and pre4-ac1 run as fine when all are IDE, but the SCSI
> option causes a hang immediately after swap is enabled - the next item is
> normally "Setting hard drive parameters for hda:", but you never see that.
Im still chasing a couple ide-scsi problems.
> The message "Warning: Primary channel requires an 80-pin cable for operation"
> is (apart from being wrongly asserted as we know) incorrect is detail:
> the plugs ARE 40-pin, the cable however is 80 conductor.
True, but I'm not sure a longer less obvious message will help users
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sat Aug 31 2002 - 22:00:14 EST