Andre et al,
Just to add some more positivity: I'm running 2.4.18-ac and 2.4.19-pre
and stable kernels (currently 2.4.19-rc3 vanilla) for a while now on my
fileserver. It has 1 onboard VIA and 2 PCI Promise controllers and a
total of 6 disks attached (every disk on its own cable). I kept the BIOS
versions of the Promise controllers up to date all the time. All disks
are running automagically - without passing kernel options - on their
max possible UDMA transfer rate, and even the 160Gb LBA48 disk is
behaving fine. The disks are in constant heavy use as fileserver for
500+ clients. With respect to IDE, the system is rock solid for a long
time now, and I have never ever seen even a little bit of data
corruption.
Regards,
- Robbert Kouprie
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with
idebus=xx
VP_IDE: IDE controller on PCI bus 00 dev 39
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
ide: Assuming 33MHz system bus speed for PIO modes; override with
idebus=xx
VP_IDE: VIA vt82c686b (rev 40) IDE UDMA100 controller on pci00:07.1
ide0: BM-DMA at 0xa000-0xa007, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xa008-0xa00f, BIOS settings: hdc:DMA, hdd:pio
PDC20269: IDE controller on PCI bus 00 dev 50
PCI: Found IRQ 11 for device 00:0a.0
PDC20269: chipset revision 2
PDC20269: not 100% native mode: will probe irqs later
PDC20269: (U)DMA Burst Bit ENABLED Primary MASTER Mode Secondary MASTER
Mode.
ide2: BM-DMA at 0xcc00-0xcc07, BIOS settings: hde:pio, hdf:pio
ide3: BM-DMA at 0xcc08-0xcc0f, BIOS settings: hdg:pio, hdh:pio
PDC20267: IDE controller on PCI bus 00 dev 58
PCI: Found IRQ 10 for device 00:0b.0
PDC20267: chipset revision 2
PDC20267: not 100% native mode: will probe irqs later
PDC20267: (U)DMA Burst Bit ENABLED Primary PCI Mode Secondary PCI Mode.
ide4: BM-DMA at 0xe000-0xe007, BIOS settings: hdi:DMA, hdj:pio
ide5: BM-DMA at 0xe008-0xe00f, BIOS settings: hdk:DMA, hdl:pio
hda: ST34321A, ATA DISK drive
hdc: Maxtor 54098U8, ATA DISK drive
hde: Maxtor 4G160J8, ATA DISK drive
hdg: WDC WD1200BB-00CAA0, ATA DISK drive
hdi: Maxtor 94098U8, ATA DISK drive
hdk: Maxtor 98196H8, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
ide2 at 0xbc00-0xbc07,0xc002 on irq 11
ide3 at 0xc400-0xc407,0xc802 on irq 11
ide4 at 0xd000-0xd007,0xd402 on irq 10
ide5 at 0xd800-0xd807,0xdc02 on irq 10
hda: 8404830 sectors (4303 MB) w/128KiB Cache, CHS=523/255/63, UDMA(33)
hdc: 80041248 sectors (40981 MB) w/2048KiB Cache, CHS=79406/16/63,
UDMA(66)
hde: 320173056 sectors (163929 MB) w/2048KiB Cache, CHS=19929/255/63,
UDMA(133)
hdg: 234441648 sectors (120034 MB) w/2048KiB Cache, CHS=232581/16/63,
UDMA(100)
hdi: 80041248 sectors (40981 MB) w/2048KiB Cache, CHS=79406/16/63,
UDMA(66)
hdk: 160086528 sectors (81964 MB) w/2048KiB Cache, CHS=158816/16/63,
UDMA(100)
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sat Sep 07 2002 - 22:00:15 EST