I can't get my Gigabyte 7ZX-1 to detect my udma66 cable. It is a brand new
ata66/100 cable so I believe that the cable is not the problem.
As seen from /proc/ide/via below it thinks my cable is a 40w (on id0 I do
have a 40w so that is correct, but in ide1 there is a 80w).
I've also tried to boot with ide1=ata66 and then it says that the transfer
rate is 66.0MB/s, but it still detects the cable as 40w. hdparam -t gave
bigger values when booting with ata66 so something changes to the better.
But I would prefer if it was autodetected and to know why it does not
work in the first place. Also I don't know what bad can come from forcing
it to ata66.
The computer is a redhat 7.3 with kernel 2.4.18-4
After searching the archives and finding others with similar problems I
really thought that booting with ata66 was going to make it detect my
cable, but no. Or maybe it does work correctly when forced even though it
still says 40w?
Any help is appreciated!
# cat /proc/ide/via
----------VIA BusMastering IDE Configuration----------------
Driver Version: 3.29
South Bridge: VIA vt82c686a
Revision: ISA 0x22 IDE 0x10
Highest DMA rate: UDMA66
BM-DMA base: 0xffa0
PCI clock: 33MHz
Master Read Cycle IRDY: 0ws
Master Write Cycle IRDY: 0ws
BM IDE Status Register Read Retry: yes
Max DRDY Pulse Width: No limit
-----------------------Primary IDE-------Secondary IDE------
Read DMA FIFO flush: yes yes
End Sector FIFO flush: no no
Prefetch Buffer: yes yes
Post Write Buffer: yes yes
Enabled: yes yes
Simplex only: no no
Cable Type: 40w 40w
-------------------drive0----drive1----drive2----drive3-----
Transfer Mode: UDMA PIO UDMA PIO
Address Setup: 30ns 120ns 30ns 120ns
Cmd Active: 90ns 90ns 90ns 90ns
Cmd Recovery: 30ns 30ns 30ns 30ns
Data Active: 90ns 330ns 90ns 330ns
Data Recovery: 30ns 270ns 30ns 270ns
Cycle Time: 60ns 600ns 60ns 600ns
Transfer Rate: 33.0MB/s 3.3MB/s 33.0MB/s 3.3MB/s
-- /Dennis- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Mon Sep 30 2002 - 22:00:36 EST