On Wednesday 09 October 2002 07:38 am, Adrian Bunk wrote:
> On Tue, 8 Oct 2002, Rob Landley wrote:
> >...
> > Go into make menuconfig in 2.4.19. Switch off "scsi support". Back to
> > the main menu, try to descend into "fusion mpt device support". The menu
> > still shows up (at the top level, I might add), but you can't go into it.
> >
> > That's been broken for over a year now. It's in the top level of
> > menuconfig. I first reported it back around 2.4.6 or so. It just doesn't
> > get in anybody's way, and that area of code is a mess, and not fixing it
> > isn't embarassing anybody specific.
> >...
>
> I assume the patch below fixes this for i386 (similar patches are needed
> for at most four other architectures)?
>
> > Rob
>
> cu
> Adrian
>
> --- l/arch/i386/config.in.old 2002-10-09 13:28:59.000000000 +0200
> +++ l/arch/i386/config.in 2002-10-09 13:31:44.000000000 +0200
> @@ -357,7 +357,11 @@
> fi
> endmenu
>
> -source drivers/message/fusion/Config.in
> +if [ "$CONFIG_SCSI" != "n" ]; then
> + if [ "$CONFIG_BLK_DEV_SD" != "n" ]; then
> + source drivers/message/fusion/Config.in
> + fi
> +fi
>
> source drivers/ieee1394/Config.in
Ah, is that how you do it? (Where were you eight months ago? :)
The bigger problem is that the sucker belongs in the SCSI menu, not in the top
level menu, so something more like... (Patch against 2.4.19)
--- linuxold/arch/i386/config.in Wed Oct 9 15:35:43 2002
+++ linux-2.4.19/arch/i386/config.in Wed Oct 9 15:41:03 2002
@@ -332,8 +332,6 @@
fi
endmenu
-source drivers/message/fusion/Config.in
-
source drivers/ieee1394/Config.in
source drivers/message/i2o/Config.in
--- linuxold/drivers/scsi/Config.in Wed Oct 9 15:39:42 2002
+++ linux-2.4.19/drivers/scsi/Config.in Wed Oct 9 15:41:52 2002
@@ -117,6 +117,7 @@
bool ' ppa/imm option - Assume slow parport control register' CONFIG_SCSI_IZIP_SLOW_CTR
fi
fi
+source drivers/message/fusion/Config.in
dep_tristate 'NCR53c406a SCSI support' CONFIG_SCSI_NCR53C406A $CONFIG_SCSI
if [ "$CONFIG_MCA" = "y" ]; then
dep_tristate 'NCR Dual 700 MCA SCSI support' CONFIG_SCSI_NCR_D700 $CONFIG_SCSI
The above "Works for me." Not that I have a fusion MPT controller, but the config
menu looks right now. :) And help says it's a specific brand of fiber channel
controller, so life is good...
Rob
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Tue Oct 15 2002 - 22:00:35 EST