hey
00:00.0 Host bridge: Acer Laboratories Inc. [ALi]: Unknown device 1671 (rev
02)
Subsystem: Hewlett-Packard Company: Unknown device 0027
Flags: bus master, medium devsel, latency 0
Memory at f0000000 (32-bit, prefetchable) [size=128M]
Capabilities: [b0] AGP version 2.0
Capabilities: [a4] Power Management version 1
00:01.0 PCI bridge: Acer Laboratories Inc. [ALi] M5247 (prog-if 00 [Normal
decode])
Flags: bus master, slow devsel, latency 0
Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
I/O behind bridge: 00009000-00009fff
Memory behind bridge: e0100000-e01fffff
Prefetchable memory behind bridge: e8000000-efffffff
00:02.0 USB Controller: Acer Laboratories Inc. [ALi] M5237 USB (rev 03)
(prog-if 10 [OH
CI])
Subsystem: Hewlett-Packard Company: Unknown device 0027
Flags: bus master, medium devsel, latency 64, IRQ 9
Memory at e0000000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [60] Power Management version 2
0:04.0 Multimedia audio controller: Acer Laboratories Inc. [ALi]: Unknown
device 5451
(rev 02)
Subsystem: Hewlett-Packard Company: Unknown device 0027
Flags: bus master, medium devsel, latency 64, IRQ 5
I/O ports at 1400 [size=256]
Memory at e0001000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [dc] Power Management version 2
00:06.0 Bridge: Acer Laboratories Inc. [ALi] M7101 PMU
Subsystem: Hewlett-Packard Company: Unknown device 0027
Flags: medium devsel
00:07.0 ISA bridge: Acer Laboratories Inc. [ALi] M1533 PCI to ISA Bridge
[Aladdin IV]
Subsystem: Hewlett-Packard Company: Unknown device 0027
Flags: bus master, medium devsel, latency 0
Capabilities: [a0] Power Management version 1
00:08.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139 (rev
10)
Subsystem: QUANTA Computer Inc: Unknown device 9904
Flags: bus master, medium devsel, latency 64, IRQ 10
I/O ports at 1800 [size=256]
Memory at e0002000 (32-bit, non-prefetchable) [size=256]
00:0a.0 CardBus bridge: Texas Instruments PCI1410 PC card Cardbus Controller
(rev 02)
Subsystem: Hewlett-Packard Company: Unknown device 0027
Flags: bus master, medium devsel, latency 168, IRQ 5
Memory at 10000000 (32-bit, non-prefetchable) [size=4K]
Bus: primary=00, secondary=02, subordinate=05, sec-latency=176
Memory window 0: 10400000-107ff000 (prefetchable)
Memory window 1: 10800000-10bff000
I/O window 0: 00004000-000040ff
I/O window 1: 00004400-000044ff
16-bit legacy interface ports at 0001
00:0b.0 Communication controller: ESS Technology ES2838/2839 SuperLink Modem
(rev 01)
Subsystem: Hewlett-Packard Company: Unknown device 0020
Flags: fast devsel, IRQ 11
I/O ports at 1010 [disabled] [size=16]
Capabilities: [c0] Power Management version 2
0:0f.0 IDE interface: Acer Laboratories Inc. [ALi] M5229 IDE (rev c4)
(prog-if fa)
Subsystem: Hewlett-Packard Company: Unknown device 0027
Flags: bus master, medium devsel, latency 64
I/O ports at 1000 [size=16]
Capabilities: [60] Power Management version 2
01:00.0 VGA compatible controller: ATI Technologies Inc: Unknown device 4c59
(prog-if 0
0 [VGA])
Subsystem: Hewlett-Packard Company: Unknown device 0027
Flags: stepping, fast Back2Back, 66Mhz, medium devsel, IRQ 11
Memory at e8000000 (32-bit, prefetchable) [size=128M]
I/O ports at 9000 [size=256]
Memory at e0100000 (32-bit, non-prefetchable) [size=64K]
Expansion ROM at <unassigned> [disabled] [size=128K]
Capabilities: [58] AGP version 2.0
Capabilities: [50] Power Management version 2
####
/dev/hda:
Model=IC25N020ATCS04-0, FwRev=CA2OA71A, SerialNo=CSL206D9H1N0MA
Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs }
RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=4
BuffType=DualPortCache, BuffSize=1768kB, MaxMultSect=16, MultSect=16
CurCHS=16383/16/63, CurSects=-66060037, LBA=yes, LBAsects=39070080
IORDY=on/off, tPIO={min:240,w/IORDY:120}, tDMA={min:120,rec:120}
PIO modes: pio0 pio1 pio2 pio3 pio4
DMA modes: mdma0 mdma1 mdma2 udma0 udma1 *udma2 udma3 udma4 udma5
AdvancedPM=yes: mode=0x80 (128)
Drive Supports : ATA/ATAPI-5 T13 1321D revision 3 : ATA-2 ATA-3 ATA-4 ATA-5
#####
#here the kernel hang up when i use alim15x3 driver to enable dma
ManOwaRR kernel: hdc: timeout waiting for DMA
ManOwaRR kernel: hdc: irq timeout: status=0x58 { DriveReady SeekComplete
DataRequest }
ManOwaRR kernel: hdc: timeout waiting for DMA
ManOwaRR kernel: hdc: irq timeout: status=0xd0 { Busy }
ManOwaRR kernel: hdc: DMA disabled
ManOwaRR kernel: scsi : aborting command due to timeout : pid 15, scsi0,
channel 0, id
0, lun 0 0x28 00 00 00 01 00 00 0$
ManOwaRR kernel: SCSI host 0 abort (pid 15) timed out - resetting\
ManOwaRR kernel: SCSI bus is being reset for host 0 channel 0.
ManOwaRR kernel: hdc: ATAPI reset complete
ManOwaRR -- MARK -
####
please any idea how to fix this and enable dma
####
_________________________________________________________________
Tired of spam? Get advanced junk mail protection with MSN 8.
http://join.msn.com/?page=features/junkmail
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sat Dec 07 2002 - 22:00:13 EST