>
> #1 How is the 40/80 pin detection done at the hardware level ?
On the motherboard end of the 80 conductor cable, the connector shorts
one of the pins to ground (maybe pin 38). The ide controller just
checks to see if the pin is pulled low or not. Pulled low = 80 pin.
That's one of the reasons it's important to plug IDE cables in the
correct way.
Ross
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Tue Jan 07 2003 - 22:00:19 EST