The patch below makes the following changes to
arch/cris/drivers/serial.c:
- remove #if'd kernel 2.0 and 2.2 compatibility code
- remove an unused #define MIN
cu
Adrian
--- linux-2.5.55/arch/cris/drivers/serial.c.old 2003-01-09 15:42:43.000000000 +0100
+++ linux-2.5.55/arch/cris/drivers/serial.c 2003-01-09 15:53:52.000000000 +0100
@@ -301,12 +301,8 @@
#include <linux/fcntl.h>
#include <linux/mm.h>
#include <linux/slab.h>
-#if (LINUX_VERSION_CODE >= 131343)
#include <linux/init.h>
-#endif
-#if (LINUX_VERSION_CODE >= 131336)
#include <asm/uaccess.h>
-#endif
#include <linux/kernel.h>
#include <asm/io.h>
@@ -323,14 +319,6 @@
/* while we keep our own stuff (struct e100_serial) in a local .h file */
#include "serial.h"
-/*
- * All of the compatibilty code so we can compile serial.c against
- * older kernels is hidden in serial_compat.h
- */
-#if defined(LOCAL_HEADERS) || (LINUX_VERSION_CODE < 0x020317) /* 2.3.23 */
-#include "serial_compat.h"
-#endif
-
#define _INLINE_ inline
static DECLARE_TASK_QUEUE(tq_serial);
@@ -639,10 +627,6 @@
#define E100_DSR_GET(info) ((*e100_modem_pins[(info)->line].port) & (1 << e100_modem_pins[(info)->line].dsr_bit))
-#ifndef MIN
-#define MIN(a,b) ((a) < (b) ? (a) : (b))
-#endif
-
/*
* tmp_buf is used as a temporary buffer by serial_write. We need to
* lock it in case the memcpy_fromfs blocks while swapping in a page,
@@ -1648,12 +1632,8 @@
restore_flags(flags);
-#if LINUX_VERSION_CODE > KERNEL_VERSION(2,1,66)
/* this includes a check for low-latency */
tty_flip_buffer_push(tty);
-#else
- queue_task_irq_off(&tty->flip.tqueue, &tq_timer);
-#endif
/* unthrottle if we have throttled */
if (E100_RTS_GET(info) &&
@@ -2600,9 +2580,7 @@
info->type = new_serial.type;
info->close_delay = new_serial.close_delay;
info->closing_wait = new_serial.closing_wait;
-#if (LINUX_VERSION_CODE > 0x20100)
info->tty->low_latency = (info->flags & ASYNC_LOW_LATENCY) ? 1 : 0;
-#endif
check_and_exit:
if (info->flags & ASYNC_INITIALIZED) {
@@ -2775,41 +2753,6 @@
/*
* This routine sends a break character out the serial port.
*/
-#if (LINUX_VERSION_CODE < 131394) /* Linux 2.1.66 */
-static void
-send_break(struct e100_serial * info, int duration)
-{
- unsigned long flags;
-
- if (!info->port)
- return;
-
- current->state = TASK_INTERRUPTIBLE;
- current->timeout = jiffies + duration;
-
- save_flags(flags);
- cli();
-
- /* Go to manual mode and set the txd pin to 0 */
-
- info->tx_ctrl &= 0x3F; /* Clear bit 7 (txd) and 6 (tr_enable) */
- info->port[REG_TR_CTRL] = info->tx_ctrl;
-
- /* wait for "duration" jiffies */
-
- schedule();
-
- info->tx_ctrl |= (0x80 | 0x40); /* Set bit 7 (txd) and 6 (tr_enable) */
- info->port[REG_TR_CTRL] = info->tx_ctrl;
-
- /* the DMA gets awfully confused if we toggle the tranceiver like this
- * so we need to reset it
- */
- *info->ocmdadr = 4;
-
- restore_flags(flags);
-}
-#else
static void
rs_break(struct tty_struct *tty, int break_state)
{
@@ -2830,19 +2773,15 @@
info->port[REG_TR_CTRL] = info->tx_ctrl;
restore_flags(flags);
}
-#endif
static int
rs_ioctl(struct tty_struct *tty, struct file * file,
unsigned int cmd, unsigned long arg)
{
struct e100_serial * info = (struct e100_serial *)tty->driver_data;
-#if defined(CONFIG_ETRAX_RS485) || (LINUX_VERSION_CODE < 131394) /* Linux 2.1.66 */
+#if defined(CONFIG_ETRAX_RS485)
int error;
#endif
-#if (LINUX_VERSION_CODE < 131394) /* Linux 2.1.66 */
- int retval;
-#endif
if ((cmd != TIOCGSERIAL) && (cmd != TIOCSSERIAL) &&
(cmd != TIOCSERCONFIG) && (cmd != TIOCSERGWILD) &&
@@ -2852,45 +2791,6 @@
}
switch (cmd) {
-#if (LINUX_VERSION_CODE < 131394) /* Linux 2.1.66 */
- case TCSBRK: /* SVID version: non-zero arg --> no break */
- retval = tty_check_change(tty);
- if (retval)
- return retval;
- tty_wait_until_sent(tty, 0);
- if (signal_pending(current))
- return -EINTR;
- if (!arg) {
- send_break(info, HZ/4); /* 1/4 second */
- if (signal_pending(current))
- return -EINTR;
- }
- return 0;
- case TCSBRKP: /* support for POSIX tcsendbreak() */
- retval = tty_check_change(tty);
- if (retval)
- return retval;
- tty_wait_until_sent(tty, 0);
- if (signal_pending(current))
- return -EINTR;
- send_break(info, arg ? arg*(HZ/10) : HZ/4);
- if (signal_pending(current))
- return -EINTR;
- return 0;
- case TIOCGSOFTCAR:
- error = verify_area(VERIFY_WRITE, (void *) arg,sizeof(long));
- if (error)
- return error;
- put_fs_long(C_CLOCAL(tty) ? 1 : 0,
- (unsigned long *) arg);
- return 0;
- case TIOCSSOFTCAR:
- arg = get_fs_long((unsigned long *) arg);
- tty->termios->c_cflag =
- ((tty->termios->c_cflag & ~CLOCAL) |
- (arg ? CLOCAL : 0));
- return 0;
-#endif
case TIOCMGET:
return get_modem_info(info, (unsigned int *) arg);
case TIOCMBIS:
@@ -3311,9 +3211,7 @@
tty->driver_data = info;
info->tty = tty;
-#if (LINUX_VERSION_CODE > 0x20100)
info->tty->low_latency = (info->flags & ASYNC_LOW_LATENCY) ? 1 : 0;
-#endif
if (!tmp_buf) {
page = get_zeroed_page(GFP_KERNEL);
@@ -3497,9 +3395,7 @@
memset(&serial_driver, 0, sizeof(struct tty_driver));
serial_driver.magic = TTY_DRIVER_MAGIC;
-#if (LINUX_VERSION_CODE > 0x20100)
serial_driver.driver_name = "serial";
-#endif
serial_driver.name = "ttyS";
serial_driver.major = TTY_MAJOR;
serial_driver.minor_start = 64;
@@ -3530,14 +3426,10 @@
serial_driver.stop = rs_stop;
serial_driver.start = rs_start;
serial_driver.hangup = rs_hangup;
-#if (LINUX_VERSION_CODE >= 131394) /* Linux 2.1.66 */
serial_driver.break_ctl = rs_break;
-#endif
-#if (LINUX_VERSION_CODE >= 131343)
serial_driver.send_xchar = rs_send_xchar;
serial_driver.wait_until_sent = rs_wait_until_sent;
serial_driver.read_proc = rs_read_proc;
-#endif
/*
* The callout device is just like normal device except for
@@ -3547,10 +3439,8 @@
callout_driver.name = "cua";
callout_driver.major = TTYAUX_MAJOR;
callout_driver.subtype = SERIAL_TYPE_CALLOUT;
-#if (LINUX_VERSION_CODE >= 131343)
callout_driver.read_proc = 0;
callout_driver.proc_entry = 0;
-#endif
if (tty_register_driver(&serial_driver))
panic("Couldn't register serial driver\n");
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Wed Jan 15 2003 - 22:00:28 EST