Hell
I reported earlier a problem with getting 2 flash disks to work in
true-IDE mode with 2.4.[18|20]
(http://www.uwsg.indiana.edu/hypermail/linux/kernel/0302.0/0918.html).
Today I tried 2.5.60. Tried with 2 flash-disks and with 1 only. With 2
flash-disks connected the kernel panics (notice, hda disappears after the
initial detection):
...
Kernel command line: BOOT_IMAGE=4 ro root=301 hdb=flash console=ttyS0,38400 console=tty1
ide_setup: hdb=flash
...
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller at PCI slot 00:07.1
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xfc90-0xfc97, BIOS settings: hda:pio, hdb:pio
hda: Hitachi CV 7.1.1, CFA DISK drive
hdb: SunDisk SDP3B-220, CFA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hdb: task_no_data_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: task_no_data_intr: error=0x04 { DriveStatusError }
hdb: 430080 sectors (220 MB) w/1KiB Cache, CHS=840/16/32, BUG
hdb:hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x04 { DriveStatusError }
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x04 { DriveStatusError }
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x04 { DriveStatusError }
hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdb: dma_intr: error=0x04 { DriveStatusError }
hdb: DMA disabled
ide0: reset: success
hdb1
hdb: hdb1
Badness in kobject_register at lib/kobject.c:152
Call Trace:
[<c01972ba>] kobject_register+0x3e/0x54
[<c015d816>] add_partition+0x56/0x60
[<c015d95a>] register_disk+0xfa/0x128
[<c01b8ed1>] add_disk+0x35/0x44
[<c01b8e70>] exact_match+0x0/0xc
[<c01b8e7c>] exact_lock+0x0/0x20
[<c01cdebe>] idedisk_attach+0x17a/0x18c
[<c01ca6f6>] ata_attach+0x46/0xac
[<c01cb23e>] ide_register_driver+0x9a/0xcc
[<c01cdedd>] idedisk_init+0xd/0x20
[<c010502c>] init+0x0/0x144
[<c0105049>] init+0x1d/0x144
[<c010502c>] init+0x0/0x144
[<c0107001>] kernel_thread_helper+0x5/0xc
...
VFS: Cannot open root device "301" or 03:01
Please append a correct "root=" boot option
Kernel panic: VFS: Unable to mount root fs on 03:01
With only one (hda) disk the system boots, but there's still an error
message:
...
Kernel command line: BOOT_IMAGE=4 ro root=301 hdb=flash console=ttyS0,38400 console=tty1
ide_setup: hdb=flash
...
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller at PCI slot 00:07.1
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xfc90-0xfc97, BIOS settings: hda:pio, hdb:pio
hda: Hitachi CV 7.1.1, CFA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: task_no_data_intr: status=0x51 { DriveReady SeekComplete Error }
hda: task_no_data_intr: error=0x04 { DriveStatusError }
hda: 31488 sectors (16 MB) w/1KiB Cache, CHS=246/4/32, BUG
hda:hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hda: dma_intr: error=0x04 { DriveStatusError }
hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hda: dma_intr: error=0x04 { DriveStatusError }
hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hda: dma_intr: error=0x04 { DriveStatusError }
hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hda: dma_intr: error=0x04 { DriveStatusError }
hda: DMA disabled
ide0: reset: success
hda1
hda: hda1
Badness in kobject_register at lib/kobject.c:152
Call Trace:
[<c01972ba>] kobject_register+0x3e/0x54
[<c015d816>] add_partition+0x56/0x60
[<c015d95a>] register_disk+0xfa/0x128
[<c01b8ed1>] add_disk+0x35/0x44
[<c01b8e70>] exact_match+0x0/0xc
[<c01b8e7c>] exact_lock+0x0/0x20
[<c01cdebe>] idedisk_attach+0x17a/0x18c
[<c01ca6f6>] ata_attach+0x46/0xac
[<c01cb23e>] ide_register_driver+0x9a/0xcc
[<c01cdedd>] idedisk_init+0xd/0x20
[<c010502c>] init+0x0/0x144
[<c0105049>] init+0x1d/0x144
[<c010502c>] init+0x0/0x144
[<c0107001>] kernel_thread_helper+0x5/0xc
...
hda: hda1
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 88k freed
The configuration:
...
#
# Bus options (PCI, PCMCIA, EISA, MCA, ISA)
#
CONFIG_PCI=y
# CONFIG_PCI_GOBIOS is not set
# CONFIG_PCI_GODIRECT is not set
CONFIG_PCI_GOANY=y
CONFIG_PCI_BIOS=y
CONFIG_PCI_DIRECT=y
...
#
# ATA/ATAPI/MFM/RLL device support
#
CONFIG_IDE=y
#
# IDE, ATA and ATAPI Block devices
#
CONFIG_BLK_DEV_IDE=y
#
# Please see Documentation/ide.txt for help/info on IDE drives
#
# CONFIG_BLK_DEV_HD_IDE is not set
# CONFIG_BLK_DEV_HD is not set
CONFIG_BLK_DEV_IDEDISK=y
CONFIG_IDEDISK_MULTI_MODE=y
# CONFIG_IDEDISK_STROKE is not set
CONFIG_BLK_DEV_IDECS=m
CONFIG_BLK_DEV_IDECD=m
# CONFIG_BLK_DEV_IDEFLOPPY is not set
CONFIG_BLK_DEV_IDESCSI=m
# CONFIG_IDE_TASK_IOCTL is not set
#
# IDE chipset support/bugfixes
#
# CONFIG_BLK_DEV_CMD640 is not set
CONFIG_BLK_DEV_IDEPCI=y
CONFIG_BLK_DEV_GENERIC=y
# CONFIG_IDEPCI_SHARE_IRQ is not set
CONFIG_BLK_DEV_IDEDMA_PCI=y
# CONFIG_BLK_DEV_IDE_TCQ is not set
# CONFIG_BLK_DEV_OFFBOARD is not set
# CONFIG_BLK_DEV_IDEDMA_FORCED is not set
# CONFIG_IDEDMA_PCI_AUTO is not set
CONFIG_BLK_DEV_IDEDMA=y
# CONFIG_IDEDMA_PCI_WIP is not set
CONFIG_BLK_DEV_ADMA=y
...
CONFIG_BLK_DEV_PIIX=y
...
CONFIG_BLK_DEV_IDE_MODES=y
...
Thanks
Guennadi
---------------------------------
Guennadi Liakhovetski, Ph.D.
DSA Daten- und Systemtechnik GmbH
Pascalstr. 28
D-52076 Aachen
Germany
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sat Feb 15 2003 - 22:00:33 EST