PCMCIA: cardmgr setting up two interfaces for one card?

From: John Weber (weber@nyc.rr.com)
Date: Thu Feb 20 2003 - 03:59:54 EST

Next message: Duncan Sands: "Re: 2.5.x freezes on booting"
Previous message: Andrew Morton: "Re: Adding 272120k swap on /dev/hda7. Priority:-2 extents:1"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

I am getting a strange error with the 2.5 kernels. If the PCMCIA card
is in the socket when I run cardmgr, cardmgr will load the appropriate
module but inexplicably sets up two interfaces (eth1 and eth2 for
example) for the same card. The first interface (eth1), in this case,
will not work -- even if i removed the modules and reinserted the card,
etc. However, if the card is NOT in the socket when I run cardmgr,
inserting the card loads the modules and sets up the interfaces
correctly. This problem does not occur in the 2.4 kernel.

Does anyone have any suggestions?

-- (o- j o h n e w e b e r //\ weber@nyc.rr.com v_/_ aim/yahoo/msn: worldwidwebers

- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/

Next message: Duncan Sands: "Re: 2.5.x freezes on booting"
Previous message: Andrew Morton: "Re: Adding 272120k swap on /dev/hda7. Priority:-2 extents:1"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b29 : Sun Feb 23 2003 - 22:00:28 EST