Olivier Bornet wrote:
> Hi all,
>
> I reply to myself, after having test this solution.
>
>
>>At this time, I have compiled and installed a 2.4.20-ac2 + some cobalt
>>patches. Is the bug also fixed in 2.4.20-ac2, or must I rebuild the
>>2.4.20 with the check commented out ?
>
>
> The 2.4.20-ac2 patched kernel help a little : the system don't crash
> anymore. But the disk is marked as defective, and is removed from the
> raid1 metadevice.
>
> One other problem with the -ac2 is the speed for the rebuild : it seems
> to be 2 times slower than with the Ducan patch. (about 2 hours instead
> of 1 hour).
>
> So, my solution is to use the patch from Ducan. I hope it (or a
> derivative form of it) will be included in the next kernel releases.
>
> Good day, and thanks all for the help.
>
Here is a 2.4.21-rc1 version of the patch, with a few modificaions
due to the changes in IDE..
Actually UDMA mode detection is not working at all for CSB5 in
2.4.21-rc1 because svwks_revision variable is set in __init function
so was reading as 0 in svwks_ratemask(). This made it think UDMA
mode 2 was the max supported, when in reality new revisions do UDMA
mode 5 and old revisions are mode 4 max.
The bad_ata100 list has been extended to include the whole family
of Barracuda ATA IV drives; we only shipped the 80gb and 40gb models
from that series so the others were not listed before.
-duncan
diff -ruN linux-2.4.21-rc1.orig/drivers/ide/pci/serverworks.c linux-2.4.21-rc1/drivers/ide/pci/serverworks.c
--- linux-2.4.21-rc1.orig/drivers/ide/pci/serverworks.c Thu Apr 24 14:16:28 2003
+++ linux-2.4.21-rc1/drivers/ide/pci/serverworks.c Thu Apr 24 14:41:26 2003
@@ -203,11 +203,22 @@
}
#endif /* defined(DISPLAY_SVWKS_TIMINGS) && defined(CONFIG_PROC_FS) */
+static int check_in_drive_lists (ide_drive_t *drive, const char **list)
+{
+ while (*list)
+ if (!strcmp(*list++, drive->id->model))
+ return 1;
+ return 0;
+}
+
static u8 svwks_ratemask (ide_drive_t *drive)
{
struct pci_dev *dev = HWIF(drive)->pci_dev;
u8 mode;
+ if (!svwks_revision)
+ pci_read_config_byte(dev, PCI_REVISION_ID, &svwks_revision);
+
if (dev->device == PCI_DEVICE_ID_SERVERWORKS_OSB4IDE) {
u32 reg = 0;
if (isa_dev)
@@ -221,13 +232,15 @@
/* Check the OSB4 DMA33 enable bit */
return ((reg & 0x00004000) == 0x00004000) ? 1 : 0;
} else if (svwks_revision < SVWKS_CSB5_REVISION_NEW) {
- return 1;
+ return 2;
} else if (svwks_revision >= SVWKS_CSB5_REVISION_NEW) {
u8 btr = 0;
pci_read_config_byte(dev, 0x5A, &btr);
- mode = btr;
+ mode = btr & 0x3;
if (!eighty_ninty_three(drive))
mode = min(mode, (u8)1);
+ if (mode == 3 && check_in_drive_lists(drive, svwks_bad_ata100))
+ mode = 2;
}
if (((dev->device == PCI_DEVICE_ID_SERVERWORKS_CSB6IDE) ||
(dev->device == PCI_DEVICE_ID_SERVERWORKS_CSB6IDE2)) &&
diff -ruN linux-2.4.21-rc1.orig/drivers/ide/pci/serverworks.h linux-2.4.21-rc1/drivers/ide/pci/serverworks.h
--- linux-2.4.21-rc1.orig/drivers/ide/pci/serverworks.h Thu Apr 24 14:16:28 2003
+++ linux-2.4.21-rc1/drivers/ide/pci/serverworks.h Thu Apr 24 14:41:41 2003
@@ -11,6 +11,16 @@
#define SVWKS_CSB5_REVISION_NEW 0x92 /* min PCI_REVISION_ID for UDMA5 (A2.0) */
#define SVWKS_CSB6_REVISION 0xa0 /* min PCI_REVISION_ID for UDMA4 (A1.0) */
+/* Seagate Barracuda ATA IV Family drives in UDMA mode 5
+ * can overrun their FIFOs when used with the CSB5 */
+const char *svwks_bad_ata100[] = {
+ "ST320011A",
+ "ST340016A",
+ "ST360021A",
+ "ST380021A",
+ NULL
+};
+
#define DISPLAY_SVWKS_TIMINGS 1
#if defined(DISPLAY_SVWKS_TIMINGS) && defined(CONFIG_PROC_FS)
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Wed Apr 30 2003 - 22:00:18 EST