Hi,
I have been continuing the track down problems with a module I am
making. If I compile the kernel and module with gcc-2.95.3, the module
installs and works correctly. If I compile the kernel and module with
gcc-3.2.3, the module finishes installation and its interrupt service
routine runs, then the kernel crashes. I am using linux 2.4.18 and 2.4.20.
The computers are all pentium computers (I, II, III, celeron, xeon) with
Redhat Linux 7.3. Any suggestions would be appreciated.
I am assuming there is a problem with my makefiles and
have attached them. I can tgz the entire driver and mail it to the list.
-- Kendrick Hamilton E.I.T. SED Systems, a division of Calian Ltd. 18 Innovation Blvd. PO Box 1464 Saskatoon, Saskatchewan Canada S7N 3R1Hamilton@sedsystems.ca Tel: (306) 933-1453 Fax: (306) 933-1486
This archive was generated by hypermail 2b29 : Fri May 23 2003 - 22:00:46 EST