On Thu, Jun 12, 2003 at 03:58:14PM +0100, Dave Jones wrote:
> > Transfer sizes, and the alignment of user buffer
> > and file offset must all be multiples of the logi-
> > cal block size of the file system.
>
> Just to confirm something that I wrote in the post-halloween-2.5 doc,
> that doesn't tally with this..
>
> - The size and alignment of O_DIRECT file IO requests now matches that
> of the device, not the filesystem. Typically this means that
> you can perform O_DIRECT IO with 512-byte granularity rather than 4k.
>
> Is this a case of the man pages not following 2.5 yet, or is this
> incorrect ?
I think of three things:
- 2.4 defines rules in most confusing manner
- 2.5 continues that
- We need more complete IRIX's O_DIRECT API:
from open(2):
O_DIRECT
If set, all reads and writes on the resulting file descriptor will
be performed directly to or from the user program buffer, provided
appropriate size and alignment restrictions are met. Refer to the
F_SETFL and F_DIOINFO commands in the fcntl(2) manual entry for
information about how to determine the alignment constraints.
O_DIRECT is a Silicon Graphics extension and is only supported on
local EFS and XFS file systems, and remote BDS file systems.
from fcntl(2):
F_SETFL Set file status flags to the third argument, ....
Flags not understood for a particular descriptor are silently
ignored except for FDIRECT. FDIRECT will return EINVAL if used
on other than an EFS, XFS or BDS file system file.
F_DIOINFO Get information required to perform direct I/O on the specified
fildes. Direct I/O is performed directly to and from a user's
data buffer. Since the kernels buffer cache is no longer
between the two, the user's data buffer must conform to the
same type of constraints as required for accessing a raw disk
partition. The third argument, arg, points to a data type
struct dioattr which is defined in the <fcntl.h> header file
and contains the following members: d_mem is the memory
alignment requirement of the user's data buffer. d_miniosz
specifies block size, minimum I/O request size, and I/O
alignment. Ths size of all I/O requests must be a multiple of
this amount and the value of the seek pointer at the time of
the I/O request must also be an integer multiple of this
amount. d_maxiosz is the maximum I/O request size which can be
performed on the fildes. If an I/O request does not meet these
constraints, the read(2) or write(2) will return with EINVAL.
All I/O requests are kept consistent with any data brought into
the cache with an access through a non-direct I/O file
descriptor. See also F_SETFL above and open(2).
> Dave
/Matti Aarnio
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sun Jun 15 2003 - 22:00:32 EST