Re: Promise module (old) broken

[Alan Pope]

On Sun, 5 Dec 2004 18:54:00 +0100, lkml@xxxxxxxxxxxxxxx
<lkml@xxxxxxxxxxxxxxx> wrote:
>   Hi,
> 
>   up to the actual kernel rc 2.6.10rc3 has broken pdc 20265 support. As
> some kernel releases ago, one had to specify i/o ports on kernel
> cmdline. 2.4.28 kernel works w/o cmdline parameter.
> 
> Is this behaviour intended? Will it be fixed in 2.6.10 release?
> 
> W/o parameter kernel (2.6) does not recognise the pdc ide controller
> drives.
> dmesg output states: "ideX: Wait for ready failed before probe !"
> 
> As of kernel rc 2.6.10rc1 the kernel even reported ide drive short
> read and seek errors on drives even not connected to the pdc
> controller but connected to the onboard controller (->/dev/hda1). In
> fact /dev/hda1 has no errors (so far).
> 
> Any comments?
> 

It's more broken than that here. I get the following errors in 2.6.8
through 2.6.9-ac9 & 2.6.10-rc2 with the old (PDC202XX_OLD) promise
driver, when placing the disk/controller under any load (in fact just
doing hdparm -t -T /dev/hde).

I get..

hde: dma_intr: status=0xff { Busy }

ide: failed opcode was: unknown
hde: DMA disabled
PDC202XX: Primary channel reset.
PDC202XX: Secondary channel reset.

(a number of times)

ide2: reset timed-out, status=0xff
end_request: I/O error, dev hde, sector 11776
Buffer I/O error on device hde, logical block 1472

(many times)

Cheers,
Al.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/