[patch 10/14] serial/crisv10: replace schedule_timeout() with msleep()

[domen]

Use msleep() instead of schedule_timeout() to guarantee the task
delays as expected. The current code uses TASK_INTERRUPTIBLE, but does not care
about signals, so I believe msleep() should be ok.

Signed-off-by: Nishanth Aravamudan <nacc@xxxxxxxxxx>
Signed-off-by: Domen Puncer <domen@xxxxxxxxxxxx>
---


 kj-domen/drivers/serial/crisv10.c |    6 ++----
 1 files changed, 2 insertions(+), 4 deletions(-)

diff -puN drivers/serial/crisv10.c~msleep-drivers_serial_crisv10 drivers/serial/crisv10.c
--- kj/drivers/serial/crisv10.c~msleep-drivers_serial_crisv10	2005-03-05 16:10:52.000000000 +0100
+++ kj-domen/drivers/serial/crisv10.c	2005-03-05 16:10:52.000000000 +0100
@@ -3757,10 +3757,8 @@ rs_write(struct tty_struct * tty, int fr
 		e100_enable_rx_irq(info);
 #endif
 
-		if (info->rs485.delay_rts_before_send > 0) {
-			set_current_state(TASK_INTERRUPTIBLE);
-			schedule_timeout((info->rs485.delay_rts_before_send * HZ)/1000);
-		}
+		if (info->rs485.delay_rts_before_send > 0)
+			msleep(info->rs485.delay_rts_before_send);
 	}
 #endif /* CONFIG_ETRAX_RS485 */
 
_
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/