bonding driver issues: slave interface not coming up

[John Jasen]

Hello;

In short, using redhat enterprise 4, we're attempting to bond two tg3
gigabit cards in XOR mode.

These cards are plugged into a cisco 2970 switch, configured with
etherchannel bonding in src-dst-mac, which looks to be mode 2.

The problem area is, upon boot, the first slave NIC does not come up.
Furthermore, running ethtool against the slave yields the following message:

[root@XXX ~]# ethtool eth0
Settings for eth0:
Cannot get device settings: Resource temporarily unavailable
        Supports Wake-on: g
        Wake-on: d
        Current message level: 0x000000ff (255)
        Link detected: no

Now, curiously enough, after boot, logging in and bringing down the
bonding interface, then bringing it back up will activate both
interfaces. ie:

ifdown bond0
ifup bond0

ethtool eth0
[root@XXX ~]# ethtool eth0
Settings for eth0:
        Supported ports: [ MII ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Half 1000baseT/Full
        Supports auto-negotiation: Yes
        Advertised link modes:  Not reported
        Advertised auto-negotiation: No
        Speed: 1000Mb/s
        Duplex: Full
        Port: Twisted Pair
        PHYAD: 1
        Transceiver: internal
        Auto-negotiation: off
        Supports Wake-on: g
        Wake-on: d
        Current message level: 0x000000ff (255)
        Link detected: yes

Attempts at debugging that we've taken and their results:

duplex/speed forced on both switch and card: no effect
turning off spanning tree protocol: no effect
enabling fastport: no effect
switching from tg3 to bcm5700 drivers: no effect
attempting to down and up the interface in /etc/rc.d/init.d/network: no
effect
attempting a script that runs after network and irqbalance to do the
same thing: no effect
putting something in rc.local to do the same: works, our current ugly
workaround
breaking the bond, using the interfaces as two independent NICS: works
restarting the bond0 interface manually: works

This problem also manifests on more than one system, which would seem to
preclude possible cable, host, or port problems.

Any ideas, or any further information I can send you to help diagnose?
Any help would be much appreciated.

--
-- John E. Jasen (jjasen@xxxxxxxxxxxxxxxxxx)
-- No one will sorrow for me when I die, because those who would
-- are dead already. -- Lan Mandragoran, The Wheel of Time, New Spring
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/