HDD LED on 82801FBM

[Michal Vanco]

Hi all,

HDD LED on my Laptop (Fujitsu-Siemens LB E8020) never goes off when 2.6 kernel 
is running (tested with 2.6.10-2.6.13.4). 

My controller is:
$ lspci | grep SATA
0000:00:1f.2 0106: Intel Corporation 82801FBM (ICH6M) SATA Controller (rev 04)

This is from my dmesg:

ahci(0000:00:1f.2) AHCI 0001.0000 32 slots 4 ports 1.5 Gbps 0x5 impl SATA mode
ahci(0000:00:1f.2) flags: 64bit ncq pm led slum part
ata1: SATA max UDMA/133 cmd 0xE0820D00 ctl 0x0 bmdma 0x0 irq 225
ata2: SATA max UDMA/133 cmd 0xE0820D80 ctl 0x0 bmdma 0x0 irq 225
ata3: SATA max UDMA/133 cmd 0xE0820E00 ctl 0x0 bmdma 0x0 irq 225
ata4: SATA max UDMA/133 cmd 0xE0820E80 ctl 0x0 bmdma 0x0 irq 225
ata1: dev 0 cfg 49:2f00 82:346b 83:7f09 84:6063 85:3469 86:3f09 87:6063 
88:203f
ata1: dev 0 ATA, max UDMA/100, 156301488 sectors: lba48
ata1: dev 0 configured for UDMA/100
scsi0 : ahci
ata2: no device found (phy stat 00000000)
scsi1 : ahci
ata3: no device found (phy stat 00000000)
scsi2 : ahci
ata4: no device found (phy stat 00000000)
scsi3 : ahci
  Vendor: ATA       Model: FUJITSU MHT2080B  Rev: 0000
  Type:   Direct-Access                      ANSI SCSI revision: 05
SCSI device sda: 156301488 512-byte hdwr sectors (80026 MB)
SCSI device sda: drive cache: write back
SCSI device sda: 156301488 512-byte hdwr sectors (80026 MB)
SCSI device sda: drive cache: write back
 sda: sda1 sda2 sda3
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0,  type 0

Is this common problem?

thanx
-michal

Attachment: pgp00000.pgp
Description: PGP signature