Re: Areca RAID driver remaining items?

[Alan Cox]

On Iau, 2006-02-23 at 17:50 +0800, erich wrote:
> But unfortunately I found some mainboards will hang up if I always enable 
> this function in my lab.
> To avoid this issue, I do an option for this case.
> 
> But  Christoph Hellwig give me comment with it.


Another thing you can also do for many of these cases is to use either
the PCI or DMI interfaces to identify the problem board and
automatically set the option as well.

There are two ways to do this. One is 

	struct pci_dev *bridge_dev = pci_get_slot(pdev->bus, PCI_DEVFN(0,0));
	if(bridge_dev) {
		if(bridge_dev->subsystem_vendor == 0xXXXX &&
			bridge_dev->subsystem_device == 0xXXXX)
			/* Match by svid/sdid for problem boards */

The other is like this

#include <linux/dmi.h>

struct dmi_system_id problem_dmi_table[] = {
	{
		.ident = "Broken Board Name 1",
		.matches = {
			DMI_MATCH(DMI_SYS_VENDOR, "EvilCorp");
			DMI_MATCH(DMI_PRODUCTNAME, "Wombat 1000");
		}
	}
	{
		ditto per board
	},
	{ }	/* End of list mark
};


And then

	if (dmi_system_check(problem_dmi_table))
		disable_msi..


The DMI code matches on the DMI strings in the ROM BIOS (the ones dumped
by 'dmidecode')


An example driver using this interface is drivers/char/sonypi.c which
uses it to make sure it *is* only run on a sony laptop.

Alan

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/