[PATCH] SCSI: link scsi_debug later (updated)

[Randy.Dunlap]

From: Randy Dunlap <rdunlap@xxxxxxxxxxxx>

Changing CONFIG_SCSI_DEBUG from =n or =m to =y can cause the enumeration
of the SATA devices to change.

Fix that by linking the scsi_debug driver after the SATA drivers.
Leave scsi_debug at the bottom of the list of low-level drivers so
that this problem doesn't happen again.

Signed-off-by: Randy Dunlap <rdunlap@xxxxxxxxxxxx>
Signed-off-by: Douglas Gilbert <dougg@xxxxxxxxxx>
---
 drivers/scsi/Makefile |    2 +-
 1 files changed, 1 insertion(+), 1 deletion(-)

--- linux-2616-rc6.orig/drivers/scsi/Makefile
+++ linux-2616-rc6/drivers/scsi/Makefile
@@ -117,7 +117,6 @@ obj-$(CONFIG_SCSI_PPA)		+= ppa.o
 obj-$(CONFIG_SCSI_IMM)		+= imm.o
 obj-$(CONFIG_JAZZ_ESP)		+= NCR53C9x.o	jazz_esp.o
 obj-$(CONFIG_SUN3X_ESP)		+= NCR53C9x.o	sun3x_esp.o
-obj-$(CONFIG_SCSI_DEBUG)	+= scsi_debug.o
 obj-$(CONFIG_SCSI_FCAL)		+= fcal.o
 obj-$(CONFIG_SCSI_LASI700)	+= 53c700.o lasi700.o
 obj-$(CONFIG_SCSI_NSP32)	+= nsp32.o
@@ -140,6 +139,7 @@ obj-$(CONFIG_SCSI_SATA_MV)	+= libata.o s
 obj-$(CONFIG_SCSI_PDC_ADMA)	+= libata.o pdc_adma.o
 
 obj-$(CONFIG_ARM)		+= arm/
+obj-$(CONFIG_SCSI_DEBUG)	+= scsi_debug.o
 
 obj-$(CONFIG_CHR_DEV_ST)	+= st.o
 obj-$(CONFIG_CHR_DEV_OSST)	+= osst.o



---
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/