Re: Linux kernel 2.6.10 sata_nv.c stops working on my hardware

[Grzegorz Adam Hankiewicz]

On 2006-06-26, Allen Martin <AMartin@xxxxxxxxxx> wrote:
> Have you tried the 2.6.9 sata_nv.c on 2.6.10?  All you should have
> to do to get it working is change the host_set->pdev references
> to use to_pci_dev().
> 
> The only functional change in sata_nv that should make any
> difference is the following:
> 
>  static struct ata_port_info nv_port_info = {
>         .sht            = &nv_sht,
>         .host_flags     = ATA_FLAG_SATA |
> -                         ATA_FLAG_SATA_RESET |
> +                         /* ATA_FLAG_SATA_RESET | */
>                           ATA_FLAG_SRST |
>                           ATA_FLAG_NO_LEGACY,
>         .pio_mask       = NV_PIO_MASK,
> 
> 
> You can try changing that back to see if it makes a difference.
> I would also investigate changes in libata too.

Actually the change you proposed works on my system. A 2.6.10 with
the ATA_FLAG_SATA_RESET works.  I did the same to a 2.6.16 kernel
but there it didn't work. I guess something else was introduced
between 2.6.10 and 2.6.16.  I'll start recompiling again everything
from 2.6.10 up to 2.6.16 with that flag turned on to see where it
stops working again.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/