Re: [PATCH] ixgb: add PCI Error recovery callbacks

[Linas Vepstas]

On Wed, Jul 05, 2006 at 08:49:27AM -0700, Auke Kok wrote:
> Zhang, Yanmin wrote:
> >On Fri, 2006-06-30 at 00:26, Linas Vepstas wrote:
> >>Adds PCI Error recovery callbacks to the Intel 10-gigabit ethernet
> >>ixgb device driver. Lightly tested, works.
> >
> >Both pci_disable_device and ixgb_down would access the device. It doesn't
> >follow Documentation/pci-error-recovery.txt that error_detected shouldn't 
> >do
> >any access to the device.
> 
> Moreover, it was Linas who wrote this documentation in the first place :)

On the pSeries, its harmless to try to do i/o; the i/o will e blocked. 

> Linas, have you tried moving the e1000_down() call into the _reset part? I 
> suspect that the e1000_reset() in there however may already be sufficient.

I wanted to perform all of the "down" type functions BEFORE the reset. 
The idea is to get the device driver and the various parts of the 
Linux kernel into a state that would be consisten with a reset.

I don't want to do these functions after the reset, since, at this
point, the card is a "clean slate"; it has the PCI bars set, but 
nothing else.  Doing random i/o to it at this point could confuse
the card; instead, one wants to bring the card up using the usual
bringup sequence.

For example, I tipped over one rather confusing bug: new code 
in the -mm tree blocks a pci_enable_device() if it thinks the
card is already enabled (even if its not). Doing I/O to a card
that is not enabled will cause either a target abort or a master 
abort.  Thus, I found I had to call pci_disable_device(); and it
seemed that the best time to do this would be before the reset, not
afterwords.  However, I did not play at length with other possibilities.

I recently lost access to my ixgb cards, and so can't do more testing
just right now.

--linas


-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/