[ANNOUNCE] sdparm 0.99

[Douglas Gilbert]

sdparm is a command line utility designed to get and set
SCSI device parameters (cf hdparm for ATA disks). The
parameters are held in mode pages. Apart from SCSI devices
(e.g. disks, tapes and enclosures) sdparm can be used on
any device that uses a SCSI command set. Virtually all CD/DVD
drives use the SCSI MMC set irrespective of the transport.
sdparm also can decode VPD pages including the device
identification page. Commands to start and stop the media;
load and unload removable media and some other housekeeping
functions are supported. sdparm supports both the lk 2.4 and
2.6 series.

This version fixes a problem that appeared in version 0.98:
A Request Sense command was added to clear down any pending
Unit Attention conditions but libata doesn't support
Request Sense. This version expands the exit status values
which are the same as those found in the recently released
sg3_utils version 1.21 .

For more information and downloads see:
http://www.torque.net/sg/sdparm.html

Changelog:
http://www.torque.net/sg/p/sdparm.ChangeLog

Doug Gilbert
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/