SOLVED: Re: JMicron 20360/20363 AHCI Controller much slower with 2.6.18

[Andrew Lyon]

> Andrew Lyon wrote:
> > Hi,
> >
> > I have a Gigabyte GA_965P_DS3 with Core 2 Duo CPU, wd raptor connected
> > to onboard JMicron 20360/20363 AHCI Controller, with 2.6.18 the drive
> > is very slow:
> >
> > beast ~ # uname -a
> > Linux beast 2.6.18 #1 SMP Wed Sep 20 15:04:24 BST 2006 i686 Intel(R)
> > Core(TM)2 C
> > PU          6600  @ 2.40GHz GNU/Linux
> > beast ~ # hdparm -t /dev/sda
> >
> > /dev/sda:
> > Timing buffered disk reads:  100 MB in  3.02 seconds =  33.10 MB/sec
>
> Which IO scheduler are you using?  If you're using anticipatory or cfq,
> can you try deadline?
>
> Thanks.
>
> --
> tejun

Very strange, I rebooted into deadline scheduler kernel, the drive
performed as fast as with 2.6.17, due to a different problem I had to
do a hard reset and the box booted back into 2.6.18 with anticipatory
scheduler, but this time the dirve performed fine!

I had initially upgraded the kernel remotely and had only done
shutdown now -r, not a hard reset, Is it generally advisable to do a
hard reset when upgrading the kernel? (ive never read that) Is there
any way to do that remotely?

One last question, I recently got a sata dvd writer for this box as
the pata ports on the jmicron were not supported, I notice there is
now support for them in 2.6.18 (with generic ide), but which would be
best supported ? the sata dvdrw or the pata? I currently have both
available and neither is installed.

Thanks
Andy
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/