[PATCH] Remove unused header file.

From: Robert P. J. Day
Date: Sat Mar 10 2007 - 17:07:28 EST


Remove apparently unused header file
drivers/net/chelsio/vsc8244_reg.h.

Signed-off-by: Robert P. J. Day <rpjday@xxxxxxxxxxxxxx>

---

not sure who the maintainer is here.

diff --git a/drivers/net/chelsio/vsc8244_reg.h b/drivers/net/chelsio/vsc8244_reg.h
deleted file mode 100644
index d3c1829..0000000
--- a/drivers/net/chelsio/vsc8244_reg.h
+++ /dev/null
@@ -1,172 +0,0 @@
-/* $Date: 2005/11/23 16:28:53 $ $RCSfile: vsc8244_reg.h,v $ $Revision: 1.1 $ */
-#ifndef CHELSIO_MV8E1XXX_H
-#define CHELSIO_MV8E1XXX_H
-
-#ifndef BMCR_SPEED1000
-# define BMCR_SPEED1000 0x40
-#endif
-
-#ifndef ADVERTISE_PAUSE
-# define ADVERTISE_PAUSE 0x400
-#endif
-#ifndef ADVERTISE_PAUSE_ASYM
-# define ADVERTISE_PAUSE_ASYM 0x800
-#endif
-
-/* Gigabit MII registers */
-#define MII_GBMR 1 /* 1000Base-T mode register */
-#define MII_GBCR 9 /* 1000Base-T control register */
-#define MII_GBSR 10 /* 1000Base-T status register */
-
-/* 1000Base-T control register fields */
-#define GBCR_ADV_1000HALF 0x100
-#define GBCR_ADV_1000FULL 0x200
-#define GBCR_PREFER_MASTER 0x400
-#define GBCR_MANUAL_AS_MASTER 0x800
-#define GBCR_MANUAL_CONFIG_ENABLE 0x1000
-
-/* 1000Base-T status register fields */
-#define GBSR_LP_1000HALF 0x400
-#define GBSR_LP_1000FULL 0x800
-#define GBSR_REMOTE_OK 0x1000
-#define GBSR_LOCAL_OK 0x2000
-#define GBSR_LOCAL_MASTER 0x4000
-#define GBSR_MASTER_FAULT 0x8000
-
-/* Vitesse PHY interrupt status bits. */
-#if 0
-#define VSC8244_INTR_JABBER 0x0001
-#define VSC8244_INTR_POLARITY_CHNG 0x0002
-#define VSC8244_INTR_ENG_DETECT_CHNG 0x0010
-#define VSC8244_INTR_DOWNSHIFT 0x0020
-#define VSC8244_INTR_MDI_XOVER_CHNG 0x0040
-#define VSC8244_INTR_FIFO_OVER_UNDER 0x0080
-#define VSC8244_INTR_FALSE_CARRIER 0x0100
-#define VSC8244_INTR_SYMBOL_ERROR 0x0200
-#define VSC8244_INTR_LINK_CHNG 0x0400
-#define VSC8244_INTR_AUTONEG_DONE 0x0800
-#define VSC8244_INTR_PAGE_RECV 0x1000
-#define VSC8244_INTR_DUPLEX_CHNG 0x2000
-#define VSC8244_INTR_SPEED_CHNG 0x4000
-#define VSC8244_INTR_AUTONEG_ERR 0x8000
-#else
-//#define VSC8244_INTR_JABBER 0x0001
-//#define VSC8244_INTR_POLARITY_CHNG 0x0002
-//#define VSC8244_INTR_BIT2 0x0004
-//#define VSC8244_INTR_BIT3 0x0008
-#define VSC8244_INTR_RX_ERR 0x0001
-#define VSC8244_INTR_MASTER_SLAVE 0x0002
-#define VSC8244_INTR_CABLE_IMPAIRED 0x0004
-#define VSC8244_INTR_FALSE_CARRIER 0x0008
-//#define VSC8244_INTR_ENG_DETECT_CHNG 0x0010
-//#define VSC8244_INTR_DOWNSHIFT 0x0020
-//#define VSC8244_INTR_MDI_XOVER_CHNG 0x0040
-//#define VSC8244_INTR_FIFO_OVER_UNDER 0x0080
-#define VSC8244_INTR_BIT4 0x0010
-#define VSC8244_INTR_FIFO_RX 0x0020
-#define VSC8244_INTR_FIFO_OVER_UNDER 0x0040
-#define VSC8244_INTR_LOCK_LOST 0x0080
-//#define VSC8244_INTR_FALSE_CARRIER 0x0100
-//#define VSC8244_INTR_SYMBOL_ERROR 0x0200
-//#define VSC8244_INTR_LINK_CHNG 0x0400
-//#define VSC8244_INTR_AUTONEG_DONE 0x0800
-#define VSC8244_INTR_SYMBOL_ERROR 0x0100
-#define VSC8244_INTR_ENG_DETECT_CHNG 0x0200
-#define VSC8244_INTR_AUTONEG_DONE 0x0400
-#define VSC8244_INTR_AUTONEG_ERR 0x0800
-//#define VSC8244_INTR_PAGE_RECV 0x1000
-//#define VSC8244_INTR_DUPLEX_CHNG 0x2000
-//#define VSC8244_INTR_SPEED_CHNG 0x4000
-//#define VSC8244_INTR_AUTONEG_ERR 0x8000
-#define VSC8244_INTR_DUPLEX_CHNG 0x1000
-#define VSC8244_INTR_LINK_CHNG 0x2000
-#define VSC8244_INTR_SPEED_CHNG 0x4000
-#define VSC8244_INTR_STATUS 0x8000
-#endif
-
-
-/* Vitesse PHY specific registers. */
-#define VSC8244_SPECIFIC_CNTRL_REGISTER 16
-#define VSC8244_SPECIFIC_STATUS_REGISTER 0x1c
-#define VSC8244_INTERRUPT_ENABLE_REGISTER 0x19
-#define VSC8244_INTERRUPT_STATUS_REGISTER 0x1a
-#define VSC8244_EXT_PHY_SPECIFIC_CNTRL_REGISTER 20
-#define VSC8244_RECV_ERR_CNTR_REGISTER 21
-#define VSC8244_RES_REGISTER 22
-#define VSC8244_GLOBAL_STATUS_REGISTER 23
-#define VSC8244_LED_CONTROL_REGISTER 24
-#define VSC8244_MANUAL_LED_OVERRIDE_REGISTER 25
-#define VSC8244_EXT_PHY_SPECIFIC_CNTRL_2_REGISTER 26
-#define VSC8244_EXT_PHY_SPECIFIC_STATUS_REGISTER 27
-#define VSC8244_VIRTUAL_CABLE_TESTER_REGISTER 28
-#define VSC8244_EXTENDED_ADDR_REGISTER 29
-#define VSC8244_EXTENDED_REGISTER 30
-
-/* PHY specific control register fields */
-#define S_PSCR_MDI_XOVER_MODE 5
-#define M_PSCR_MDI_XOVER_MODE 0x3
-#define V_PSCR_MDI_XOVER_MODE(x) ((x) << S_PSCR_MDI_XOVER_MODE)
-#define G_PSCR_MDI_XOVER_MODE(x) (((x) >> S_PSCR_MDI_XOVER_MODE) & M_PSCR_MDI_XOVER_MODE)
-
-/* Extended PHY specific control register fields */
-#define S_DOWNSHIFT_ENABLE 8
-#define V_DOWNSHIFT_ENABLE (1 << S_DOWNSHIFT_ENABLE)
-
-#define S_DOWNSHIFT_CNT 9
-#define M_DOWNSHIFT_CNT 0x7
-#define V_DOWNSHIFT_CNT(x) ((x) << S_DOWNSHIFT_CNT)
-#define G_DOWNSHIFT_CNT(x) (((x) >> S_DOWNSHIFT_CNT) & M_DOWNSHIFT_CNT)
-
-/* PHY specific status register fields */
-#define S_PSSR_JABBER 0
-#define V_PSSR_JABBER (1 << S_PSSR_JABBER)
-
-#define S_PSSR_POLARITY 1
-#define V_PSSR_POLARITY (1 << S_PSSR_POLARITY)
-
-#define S_PSSR_RX_PAUSE 2
-#define V_PSSR_RX_PAUSE (1 << S_PSSR_RX_PAUSE)
-
-#define S_PSSR_TX_PAUSE 3
-#define V_PSSR_TX_PAUSE (1 << S_PSSR_TX_PAUSE)
-
-#define S_PSSR_ENERGY_DETECT 4
-#define V_PSSR_ENERGY_DETECT (1 << S_PSSR_ENERGY_DETECT)
-
-#define S_PSSR_DOWNSHIFT_STATUS 5
-#define V_PSSR_DOWNSHIFT_STATUS (1 << S_PSSR_DOWNSHIFT_STATUS)
-
-#define S_PSSR_MDI 6
-#define V_PSSR_MDI (1 << S_PSSR_MDI)
-
-#define S_PSSR_CABLE_LEN 7
-#define M_PSSR_CABLE_LEN 0x7
-#define V_PSSR_CABLE_LEN(x) ((x) << S_PSSR_CABLE_LEN)
-#define G_PSSR_CABLE_LEN(x) (((x) >> S_PSSR_CABLE_LEN) & M_PSSR_CABLE_LEN)
-
-//#define S_PSSR_LINK 10
-//#define S_PSSR_LINK 13
-#define S_PSSR_LINK 2
-#define V_PSSR_LINK (1 << S_PSSR_LINK)
-
-//#define S_PSSR_STATUS_RESOLVED 11
-//#define S_PSSR_STATUS_RESOLVED 10
-#define S_PSSR_STATUS_RESOLVED 15
-#define V_PSSR_STATUS_RESOLVED (1 << S_PSSR_STATUS_RESOLVED)
-
-#define S_PSSR_PAGE_RECEIVED 12
-#define V_PSSR_PAGE_RECEIVED (1 << S_PSSR_PAGE_RECEIVED)
-
-//#define S_PSSR_DUPLEX 13
-//#define S_PSSR_DUPLEX 12
-#define S_PSSR_DUPLEX 5
-#define V_PSSR_DUPLEX (1 << S_PSSR_DUPLEX)
-
-//#define S_PSSR_SPEED 14
-//#define S_PSSR_SPEED 14
-#define S_PSSR_SPEED 3
-#define M_PSSR_SPEED 0x3
-#define V_PSSR_SPEED(x) ((x) << S_PSSR_SPEED)
-#define G_PSSR_SPEED(x) (((x) >> S_PSSR_SPEED) & M_PSSR_SPEED)
-
-#endif
--
========================================================================
Robert P. J. Day
Linux Consulting, Training and Annoying Kernel Pedantry
Waterloo, Ontario, CANADA

http://fsdev.net/wiki/index.php?title=Main_Page
========================================================================
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/