Re: How to get an IDE Hard Reset, not a Soft Reset?

[Ralph Corderoy]

Hi Ondrej,

Ondrej Zary wrote:
> Ralph Corderoy wrote:
> > As I understand it, an IDE hard drive can be reset in three ways.  A
> > power-on reset, a hard reset caused by pin 1 (RESET-) on the IDE
> > connector, and a soft reset (bit SRST in the device control
> > register).  RESET- is held low on a power on, but can also be used
> > later to do a hard reset.
> 
> The RESET pin is often wired to the system RESET signal, so there is
> no way to control it separately.

Yes, I think you're correct.  I found a south bridge spec.,
http://www.tser.org/vt8231/vt8231.pdf, and I don't see a pin for driving
an IDE RESET-.

Oh well, I suppose I either dike out RESET- from the IDE cable and wire
it up to a serial or parallel port, or give up using a PC for the task
and use a dedicated circuit.

Thanks for your help.


Ralph.

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/