Re: understanding firmware loader for speedtouch (kernel 2.6.21.5)

[mikie]

2007/7/9, Duncan Sands <duncan.sands@xxxxxxxxxxxxxx>:
> > One more thing - when the modem finally runs in isochronous mode, yet
> > I cannot get high transfer rates. I can't get nothing more than
> > 3Mbits/s. When I used kernel 2.4 with bulk mode I had only 2.5 Mbit/s.
> > So there is a little progress, but still not too much. Is it possible
> > that weak and old hardware (Celeron 633 on a VIA chipset motherboard)
> > is causing this ?
>
> Is it actually running in isochronous mode?  (It prints some messages
> about this).

This is what I get:
root@srv:/# cat /sys/module/speedtch/parameters/enable_isoc
Y

I think it means it confirms the isochronous mode is working.
Especially that I modified the source of the speedtch.c so that the
enable_isoc is on by default.


> You may need new firmware (I've attached some recent
> firmware that was made available by Thomson UK without any licence
> conditions).

Many thanks for your great support. I will try the new firmware
tomorrow, as this is a remote machine and I would now risk loosing it
for an entire evening and night in case something goes wrong (usually
it just does go wrong :)

--
Regards,
MK
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/