[PATCH] lro: myri10ge example how to use LRO

From: Andrew Gallatin
Date: Fri Aug 03 2007 - 13:20:38 EST

Next message: Jeff Dike: "[PATCH 0/2] UML - Console fixes and cleanups for 2.6.24"
Previous message: Oleg Nesterov: "Re: [NFS] 2.6.23-rc1-mm2"
Next in thread: Kok, Auke: "Re: [PATCH] lro: myri10ge example how to use LRO"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

To follow up on Jan-Bernd Themann's LRO patch earlier today,
this patch shows how the generic LRO interface can be used for
page based drivers.

Again, many thanks to Jan-Bernd Themann for leading this effort.

Drew

Singed off by: Andrew Gallatin <gallatin@xxxxxxxx> diff -urNp a/drivers/net/myri10ge/myri10ge.c b/drivers/net/myri10ge/myri10ge.c
--- a/drivers/net/myri10ge/myri10ge.c 2007-07-24 15:57:12.000000000 -0400
+++ b/drivers/net/myri10ge/myri10ge.c 2007-08-03 13:07:48.000000000 -0400
@@ -48,6 +48,7 @@
#include <linux/etherdevice.h>
#include <linux/if_ether.h>
#include <linux/if_vlan.h>
+#include <linux/inet_lro.h>
#include <linux/ip.h>
#include <linux/inet.h>
#include <linux/in.h>
@@ -62,6 +63,8 @@
#include <linux/io.h>
#include <linux/log2.h>
#include <net/checksum.h>
+#include <net/ip.h>
+#include <net/tcp.h>
#include <asm/byteorder.h>
#include <asm/io.h>
#include <asm/processor.h>
@@ -89,6 +92,7 @@ MODULE_LICENSE("Dual BSD/GPL");

#define MYRI10GE_EEPROM_STRINGS_SIZE 256
#define MYRI10GE_MAX_SEND_DESC_TSO ((65536 / 2048) * 2)
+#define MYRI10GE_MAX_LRO_DESCRIPTORS 8

#define MYRI10GE_NO_CONFIRM_DATA htonl(0xffffffff)
#define MYRI10GE_NO_RESPONSE_RESULT 0xffffffff
@@ -151,6 +155,8 @@ struct myri10ge_rx_done {
dma_addr_t bus;
int cnt;
int idx;
+ struct net_lro_mgr lro_mgr;
+ struct net_lro_desc lro_desc[MYRI10GE_MAX_LRO_DESCRIPTORS];
};

struct myri10ge_priv {
@@ -276,6 +282,14 @@ static int myri10ge_debug = -1; /* defau
module_param(myri10ge_debug, int, 0);
MODULE_PARM_DESC(myri10ge_debug, "Debug level (0=none,...,16=all)");

+static int myri10ge_lro = 1;
+module_param(myri10ge_lro, int, S_IRUGO);
+MODULE_PARM_DESC(myri10ge_lro, "Enable large receive offload\n");
+
+static int myri10ge_lro_max_pkts = MYRI10GE_LRO_MAX_PKTS;
+module_param(myri10ge_lro_max_pkts, int, S_IRUGO);
+MODULE_PARM_DESC(myri10ge_lro, "Number of LRO packets to be aggregated\n");
+
static int myri10ge_fill_thresh = 256;
module_param(myri10ge_fill_thresh, int, S_IRUGO | S_IWUSR);
MODULE_PARM_DESC(myri10ge_fill_thresh, "Number of empty rx slots allowed\n");
@@ -1019,6 +1033,15 @@ myri10ge_rx_done(struct myri10ge_priv *m
remainder -= MYRI10GE_ALLOC_SIZE;
}

+ if (mgp->csum_flag && myri10ge_lro) {
+ rx_frags[0].page_offset += MXGEFW_PAD;
+ rx_frags[0].size -= MXGEFW_PAD;
+ len -= MXGEFW_PAD;
+ lro_receive_frags(&mgp->rx_done.lro_mgr, rx_frags,
+ len, len, (void *)(unsigned long)csum, csum);
+ return 1;
+ }
+
hlen = MYRI10GE_HLEN > len ? len : MYRI10GE_HLEN;

/* allocate an skb to attach the page(s) to. */
@@ -1137,6 +1160,9 @@ static inline void myri10ge_clean_rx_don
mgp->stats.rx_packets += rx_packets;
mgp->stats.rx_bytes += rx_bytes;

+ if (myri10ge_lro)
+ lro_flush_all(&rx_done->lro_mgr);
+
/* restock receive rings if needed */
if (mgp->rx_small.fill_cnt - mgp->rx_small.cnt < myri10ge_fill_thresh)
myri10ge_alloc_rx_pages(mgp, &mgp->rx_small,
@@ -1378,7 +1404,8 @@ static const char myri10ge_gstrings_stat
"dropped_pause", "dropped_bad_phy", "dropped_bad_crc32",
"dropped_unicast_filtered", "dropped_multicast_filtered",
"dropped_runt", "dropped_overrun", "dropped_no_small_buffer",
- "dropped_no_big_buffer"
+ "dropped_no_big_buffer", "LRO aggregated", "LRO flushed",
+ "LRO avg aggr", "LRO no_desc"
};

#define MYRI10GE_NET_STATS_LEN 21
@@ -1444,6 +1471,14 @@ myri10ge_get_ethtool_stats(struct net_de
data[i++] = (unsigned int)ntohl(mgp->fw_stats->dropped_overrun);
data[i++] = (unsigned int)ntohl(mgp->fw_stats->dropped_no_small_buffer);
data[i++] = (unsigned int)ntohl(mgp->fw_stats->dropped_no_big_buffer);
+ data[i++] = mgp->rx_done.lro_mgr.stats.aggregated;
+ data[i++] = mgp->rx_done.lro_mgr.stats.flushed;
+ if (mgp->rx_done.lro_mgr.stats.flushed)
+ data[i++] = mgp->rx_done.lro_mgr.stats.aggregated /
+ mgp->rx_done.lro_mgr.stats.flushed;
+ else
+ data[i++] = 0;
+ data[i++] = mgp->rx_done.lro_mgr.stats.no_desc;
}

static void myri10ge_set_msglevel(struct net_device *netdev, u32 value)
@@ -1717,10 +1752,69 @@ static void myri10ge_free_irq(struct myr
pci_disable_msi(pdev);
}

+static int
+myri10ge_get_frag_header(struct skb_frag_struct *frag, void **mac_hdr,
+ void **ip_hdr, void **tcpudp_hdr,
+ u64 * hdr_flags, void *priv)
+{
+ struct ethhdr *eh;
+ struct vlan_ethhdr *veh;
+ struct iphdr *iph;
+ u8 *va = page_address(frag->page) + frag->page_offset;
+ unsigned long ll_hlen;
+ __wsum csum = (__wsum) (unsigned long)priv;
+
+ /* find the mac header, aborting if not IPv4 */
+
+ eh = (struct ethhdr *)va;
+ *mac_hdr = eh;
+ ll_hlen = ETH_HLEN;
+ if (eh->h_proto != htons(ETH_P_IP)) {
+ if (eh->h_proto == htons(ETH_P_8021Q)) {
+ veh = (struct vlan_ethhdr *)va;
+ if (veh->h_vlan_encapsulated_proto != htons(ETH_P_IP))
+ return -1;
+
+ ll_hlen += VLAN_HLEN;
+
+ /*
+ * HW checksum starts ETH_HLEN bytes into
+ * frame, so we must subtract off the VLAN
+ * header's checksum before csum can be used
+ */
+ csum = csum_sub(csum, csum_partial(va + ETH_HLEN,
+ VLAN_HLEN, 0));
+ } else {
+ return -1;
+ }
+ }
+ *hdr_flags = LRO_IPV4;
+
+ iph = (struct iphdr *)(va + ll_hlen);
+ *ip_hdr = iph;
+ if (iph->protocol != IPPROTO_TCP)
+ return -1;
+ *hdr_flags |= LRO_TCP;
+ *tcpudp_hdr = (u8 *) (*ip_hdr) + (iph->ihl << 2);
+
+ /* verify the IP checksum */
+ if (unlikely(ip_fast_csum((u8 *) iph, iph->ihl)))
+ return -1;
+
+ /* verify the checksum */
+ if (unlikely(csum_tcpudp_magic(iph->saddr, iph->daddr,
+ ntohs(iph->tot_len) - (iph->ihl << 2),
+ IPPROTO_TCP, csum)))
+ return -1;
+
+ return 0;
+}
+
static int myri10ge_open(struct net_device *dev)
{
struct myri10ge_priv *mgp;
struct myri10ge_cmd cmd;
+ struct net_lro_mgr *lro_mgr;
int status, big_pow2;

mgp = netdev_priv(dev);
@@ -1852,6 +1946,18 @@ static int myri10ge_open(struct net_devi
mgp->link_state = htonl(~0U);
mgp->rdma_tags_available = 15;

+ lro_mgr = &mgp->rx_done.lro_mgr;
+ lro_mgr->dev = dev;
+ lro_mgr->features = LRO_F_NAPI;
+ lro_mgr->ip_summed = CHECKSUM_COMPLETE;
+ lro_mgr->ip_summed_aggr = CHECKSUM_UNNECESSARY;
+ lro_mgr->max_desc = MYRI10GE_MAX_LRO_DESCRIPTORS;
+ lro_mgr->lro_arr = mgp->rx_done.lro_desc;
+ lro_mgr->get_frag_header = myri10ge_get_frag_header;
+ lro_mgr->max_aggr = myri10ge_lro_max_pkts;
+ if (lro_mgr->max_aggr > MAX_SKB_FRAGS)
+ lro_mgr->max_aggr = MAX_SKB_FRAGS;
+
netif_poll_enable(mgp->dev); /* must happen prior to any irq */

status = myri10ge_send_cmd(mgp, MXGEFW_CMD_ETHERNET_UP, &cmd, 0);

Next message: Jeff Dike: "[PATCH 0/2] UML - Console fixes and cleanups for 2.6.24"
Previous message: Oleg Nesterov: "Re: [NFS] 2.6.23-rc1-mm2"
Next in thread: Kok, Auke: "Re: [PATCH] lro: myri10ge example how to use LRO"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]