Re: [Pcihpd-discuss] [PATCH 1/3] pciehp: hotplug: deal with pre-insertedExpressCards

[Kenji Kaneshige]

> If a PCIe ExpressCard34 is inserted into the slot *before*
> I modprobe pciehp (with pciehp_force=1), then the card is not
> detected nor enabled.  The patch provided here fixes that.
>
> > Could you give me answers against the following questions?
> >
> >  (1) Did you try "echo 1 > /sys/bus/pci/slots/XXX/power"?
> >      (XXX is the slot number to which your card had been inserted)
> >  (2) If the answer against (1) is yes, did "echo 1 > ..." work?
>
>
> After 1. inserting the card, and then 2. modprobing pciehp,
> the value of /sys/bus/pci/slots/XXX/power is already "1".

According to pciehp_debug output from you, your slot doesn't
have software programmable power controller. So your hardware
automatically power on the slot. I think this is why the value
of "power" file is already "1". (But I'm not sure if it is
correct, especially because your firmware doesn't have _OSC.)

On the other hand, my slot has software programmable power
controller. So the value of "power" file is "0" in this case. 

> But, yes, doing "echo 1" into it does trigger card detection
> and things work afterwards.  This doesn't really help,
> because it doesn't happen automatically, unless the kernel patch
> is applied.
>
> >  (6) I think your slot is surprise removable. Is it correct?
>
> Yes, it's an externally accessible ExpressCard slot on a notebook,
> which is intended to be fully hotpluggable by surprise or otherwise.

Ok. I think your patch is trying to solve the following two
problems. Right?

 - When the card is inserted *after* modprobing pciehp, the card
   is automatically enabled (pciehp tries to automatically enable
   slot when the card is inserted if the slot is surprise remove
   capable). But if the card is inserted *before* modprobing
   pciehp, the card is not automatically enabled even after
   modprobing pciehp.

 - When the card is inserted *before* modprobing pciehp, the card
   is automatically powered on by hardware, but it is not detected
   by OS. That is, "power" file tells the card is working, but it
   is not working actually. It is strange.

But those are not problems on the slot which is not surprise remove
capable and has software programmable power controller because:

 - When the card is inserted *after* modprobing pciehp, the card
   is *not* automatically powered on/detected. So it is very
   natural that the card, which had been inserted before modprobing
   pciehp, is not automatically enabled at the pciehp modprobe time.

 - When the card is inserted *before* modprobing pciehp, the card
   is not automatically powered on by hardware if the slot has
   sortware programmable power controller. So there is no
   contradiction.

I think your patch has a bad effect to this kind of slots. So I
think your patch needs additional checks to see if the slot should
be enabled or not.

And you need to test your patch on PCIe Native hotplug capable
hardware:)

Thanks,
Kenji Kaneshige





-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/